Kuryakyn Pakmaster 444168 User manual

PARTS INCLUDED
1 Rain Cover
1 Installation Instructions
Please read and understand entire instructions before starting installation.
THANK YOU FOR CHOOSING KϋRYAKYN!
IN ORDER TO PROTECT YOU AND OTHERS FROM POSSIBLE INJURY AND/OR
PROPERTY DAMAGE OR LOSS, PLEASE PAY CLOSE ATTENTION TO ALL
INSTRUCTIONS, WARNINGS, CAUTIONS AND ATTENTION NOTES REGARDING
THE USE AND CARE OF THIS PRODUCT.
WARNING! THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING
THE CONTENTS DESCRIBED HEREIN CAN RESULT IN
POTENTIAL DEATH OR SERIOUS INJURY
ATTENTION! This indication alerts you to the fact that ignoring the contents
described herein may negatively affect product performance and
functionality.
TOOLS SUGGESTED
None needed
STRICTLY OBSERVE THE FOLLOWING GUIDELINES IN ORDER TO USE THE
PRODUCT PROPERLY AND AVOID POTENTIALLY DANGEROUS ACCIDENTS.
STEP 1 Read and understand all steps in the instructions before starting the
installation. Park the motorcycle on a hard, level surface and turn off the
ignition.
STEP 2 The Pakmaster should be off the bike for ease of installing the rain cover.
NOTE: The handle of the bag faces towards the front of the
bike
STEP 3 Make sure the rear straps and
hooks are snapped on the correct
snap before proceeding to STEP 4.
Top snap for use with no luggage
rack, Bottom snap for use with
a luggage rack.
PIC1
PAKMASTER RAIN COVER PART# 444168
444168-31HD-1010
-cont.-
PIC 1
WITHOUT RACK
WITH RACK

PAGE
2
STEP 4 Pull the cover over the bag. The
front of the cover is the part with
the two protected slots for the
straps of the bag.
PIC2
STEP 5 Pull the front straps through the opening
in the rain cover. Pull the rear straps
through the rain cover.
STEP 6 Tip the front of the bag up and attach the rear hold down
hooks to the lip of the tour pack. PIC 3 and PIC 4
STEP 7 Using the drawstring at lower back of bag, pull to snug the rain cover to the baq. PIC 4
NOTE: Be sure to tuck extra drawstring
cord inside the rain cover so it
does not mar the tour pack.
STEP 8 Hook the front straps to the front bracket and `
adjust to hold bag securely to bracket. PIC 5
ATTENTION! Secure all straps away from visible painted surfaces, moving parts, pinch points
or extreme heat.
ATTENTION! It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not issue a warranty on components lost due to improper installation. Periodic
maintenance may be required.
Ride On!
PAKMASTER RAIN COVER INSTALLATION
PIC 3
TIP UP
PIC 4
HOOK HERE
UNDER LID
DRAWSTRING
PIC 5
HOOK FRONT STRAPS
PIC 2 SLOT FOR FRONT