Kuryakyn 7312 User manual

 
607312L 2 FairingLEDLightAssemblies
607312W 2 38”WireExtensions
607312P 2 MirrorLight“Y”AdapterPlug
307312 1 InstallationInstructions
Please read and understand entire instructions before starting installation.


Itistheinstallers’responsibilitytomakesureallfasteners(includingpre-assembled)are
tightenedbeforeoperationofmotorcycle.Küryakynwillnotwarrantycomponentsthatare
lostduetoimproperinstallation.Periodicmaintenancemayberequired.

Glasscleaner,Papertowels

 SeePIC.1.Oneachsideofthebike,“peel”therubberbootatthebaseofeach
mirrorbackfromthefairing.Payattentionhowthisattachestothefairing,asthiswill
simplifyre-assembly.
 SeePIC.2.Removethefairingtrimmoldingthatrunsalongeachsideofthefairing
–thismoldingsnapsintoplace.
 Foreachside,plugoneofthe38”wireextensionsintooneofthe“Y”adapter
plugs.Oneach“Y”plug,eitheroftheplug-inscanbeused.Theremainingplugwillbeforthe
Küryakynmirrorlights(notincluded),thesecanbeaddedlater.Routethiswirethroughthe
snapinfairingsidemoldingcavityintothebaseareaofthemirror.



7312-13GL-0806
   




 SeePIC.3.Lookforthe3-wireturnsignal/runninglightconnectorsundertherubberboots,
wherethemirrorsjointhefairing(peeledbackinSTEP1).Disconnecttheseplugs(oneeachside).See
PIC.4.InserttheKüryakyn“Y”adaptersin-line–theywillsnapintoplace.
 Fromthe“Y”adapters,routethe38”wireextensionsalongtheedgeofthefairing
wherethetrimmoldingswereremovedearlier(PIC.2).Inthemostdirect,leastconspicuous
routepossible,stringthewireextensionssotheremainingplugendsupattherearendofthe
chromestripabovethecylinderheads.Removethesmallclearplastic“airfoils”attheendsof
thesestrips.
 Withglasscleaner,thoroughlycleanthechromestrips.Removetheadhesive
backingfromeachofthelightsandaffixthemtothechromestrips.
 CarefullyplugtheextensionintothelightasshowninPIC.5.
 Replacetherubberbootontothefairinginthesamemanneritwasremoved.
 Replacethefairingtrimmoldingonthefairingbysnappingitintoplace.
TestforproperrunandturnfunctionWITH THE BIKE RUNNING.Iftherunning
lightrunsinthebrightmode,andtheturnsignalflashesinthedimmode,simplyremovethe
plugfromthelight,invertit,andre-plugitintothelight.

Ride On!


 




