Kuryakyn 4767 User manual


  1 SmokeLaydownTaillightLens
  1 Reflector
  1 IridiumCoatedRedBulb
  1 BulbSocketwithConnector
  1 Gasket
  1 InstallationInstructions
Please read and understand entire instructions before starting installation.

ATTENTION!Itistheinstaller’sresponsibilitytoensureallfasteners(includingpre-assembled)
aretightenedbeforeoperationofthemotorcycle.Küryakynwillnotwarranty
componentslostduetoimproperinstallation.Periodicmaintenancemaybe
required.
  Installationisshownona2005HeritageSoftail®;whilerepresentativeoftypical
procedure,theremaybeminordifferenceswheninstalledonothermodels.

Phillipsheadscrewdriver

 Parkthemotorcycleonahard,levelsurface;turnofftheignition.
 Removethetwostockphillipsheadscrewssecuringthetaillightlenstothebase.
SeePIC.1A.Setthescrewsaside,theywillbere-used.
 Unplug
thestocktaillight
bulbconnector
fromthebase.
SeePIC.1B.Push
uponthetabon
theundersideof
theconnectorand
pullitoutofthe
socket;setthe
stocktaillightbulb
connectoraside,it
willnotbere-used.




4767-11HD-0407
  





 Removetheadhesivebackingfromtheincludedgasket;positionthegasketasshowninPIC.1C
andpressintoplace.
 Plugtheincludedbulbsocketconnectorintothesocketinthebase.SeePIC.1D.
 Pushinandtwisttheincludedbulbclockwiseintothenewbulbsocket.Theincludedbulbonly
fitsinthesocketoneway.
 Positionthebulbsocketinthebackoftheincludedreflector;pushthesocketintothereflector.
SeePIC.2.

 Tuckthesocketwiresintotherecessinthe
taillightbase.
 Placetheincludedtaillightlensoverthe
reflectorandsecureitwiththetwoscrewsremovedin
STEP2.
 Ensurethatthetaillightandbrakelight
operateproperlybeforeoperatingthemotorcycle.
Ride On!


 


 


