Laserworld GREEN-4000 User manual

GREEN-4000
USER MANUAL
Please read this manual carefully before you initially start-up!

USER MANUAL: Laserworld GREEN-4000
Date: 01/2008
Page 2of 2
DANGER LASER RADIATION!
Avoid direct eye exposure!
Laser radiation can cause eye damage and/or skin damage
All protective measures for a safe operation of this laser must be applied.
1. SAFETY INSTRUCTIONS
- If the device has been exposed to drastic temperature fluctuation, do not
switch it on immediately. The arising condensation water might damage your
device. Leave the device switched off until it has reached room temperature.
- The laser must only be used for shows. The operation is only allowed if it is
controlled by a skilled and well-trained operator.
- Never leave this device running unattended and keep it away from children
and unauthorized persons.
- Keep away from heaters and other heating sources. In order to safeguard
sufficient ventilation, leave 50 cm of free space around the device.
- Never direct the laser beam to people or animals.
- CAUTION LASER DIODE: Never unscrew the housing!
There are no serviceable parts inside the device. Maintenance and service
operations shall only be carried out by authorized dealers.
- Always disconnect from the mains when the device is not in use or before
cleaning it.
- HEALTH HAZARD! Never look directly into the light source, as
sensitive persons may suffer an epileptic shock!

USER MANUAL: Laserworld GREEN-4000
Date: 01/2008
Page 3of 3
Green diode pumped solid state lasers:
GREEN-4000
Low cost solid state 532 green laser - used in collimation, laser medical
treatment, scientific experimentation, optics instrument, laser display, and
lighting etc.
Technical Specifications:
low cost laser diode with analogue modulated PSU
GREEN: guaranteed: 3,5W/532nm; typical: 4W/532nm
Operating mode: CW
Warm-up time (minutes): <15min
Power stability (rms, over 4 hours): <5%
M2 factor: <1,2
Beam divergence, full angle (mrad): <1.5
Beam diameter at the aperture (mm): ~2mm
Beam height from base: 24,8mm
Spectral linewidth: <0,1nm
Polarization ration: >100:1 (0 or 90 degree)
Operating temperature: 10-35°C
Expected lifetime: 10000 hours
Power Supply: 230V 50/60 Hz
Analogue modulation: 10KHz

USER MANUAL: Laserworld GREEN-4000
Date: 01/2008
Page 4of 4
EU- Declaration of Conformity
We hereby confirm that the following device
Laserworld GREEN-4000
complies with the essential safety requirements, laid down in the regulations of the
committee to assimilate the provisions of law of all participating EU states on the
electromagnetic compatibility (98/336/EWG).
The device has been classified considering the following EU-norms on
electromagnetic compatibility:
DIN EN 55103-1: 1996
DIN EN 55103-2: 1996
DIN EN 61000-3-2:2000 + A2: 2005
DIN EN 61000-3-3:1995 + A1: 2001
Assessment of compliance of the product with the requirements relating to the Low Voltage
Directive (LVD) was based on the following standards:
DIN EN 60065 : 2002
This declaration is executed on behalf of the GREEN-4000 Importer:
Laserworld (Switzerland) AG
Oberstrasse 1
8274 Tägerwilen
SWITZERLAND
Authorized person:
Supervisory board Ms Rhea Gössel
place of business: 8274 Tägerwilen / SWITZERLAND
company number: CH-440.3.020.548-6
Commercial Registry Kanton Thurgau
www.laserworld.com
[email protected]
representative according to EMVG:
Cleantech Europe GmbH
Managing Director: Thomas Schulze
Fürkhofstr. 5
81927 München / DE