#656 Clamp on Meat Tenderizer
BEFORE USE
Thoroughly hand-wash all parts, before first use, in warm soapy water to remove the lubricant
applied during manufacturing.
Read these instructions before operating meat tenderizer.
•Never operate unit without the cover in place. The turning action of the rollers could pull
fingers and hands into the rollers and cause serious injury.
•Drop meat through the opening of the cover. DO NOT attempt to force meat into the
opening. Turning action of the rollers will carry appropriately sized portions of meat into the
unit.
•Use boneless cuts of meat only. Meat should not exceed ½” in thickness. Remove gristle
before tenderizing. To experience the maximum tenderness, run meat through the
tenderizer twice at right angles. KEEP HANDS A SAFE DISTANCE FROM THE EXPOSED
ROLLERS ON THE BOTTOM OF THE UNIT.
Assembly
Unit comes partially assembled.
•On Main Frame (#2) loosen adjusting screw to lowest point on clamp.
•Attach Main Frame (#2) to a flat surface by hand tightening the adjusting screw. Do not
over tighten.
•Attach Handle (#1) with Locking Screw (#3).
•Attach Plate (#8). Hold the Main Frame (#2) in your left hand with the driven roller (#5)
nearest you (as shown in the schematic). In your right hand hold the plate (#8), with the
biggest curved hook at the top and facing away from the tenderizer. Insert the plate (#8)
between the driven roller and the bottom bar (#7). Loop the curved hook over the bottom
bar (#7) and rest it on the Main Frame notch.
•Snap Cover (#6) in place over entire unit. (Cut out towards the handle side.)
To Clean
•Remove Cover.
•Remove Locking screw to remove handle.
•Loosen adjusting screw and remove Main Frame from table.
•Wash with hot soapy water. Rinse and dry parts thoroughly.
•Spray with Silicon Spray (available at LEM Products) to keep your tenderizer looking like
new.
Warnings and Precautions
•Keep out of reach of children.
•Do not operate without the protective cover in place.
LEM Products ♦109 May Drive ♦Harrison, OH 45030
Toll Free: 1-877-536-7763 ♦www.lemproducts.com
