Life Fitness Club Series User manual

CLUBSERIESVERTICAL
KNEERAISE
Part # 7335201
Rev.C Revision:11/15/021
ASSEMBLY INSTRUCTIONS

PARTS LIST
PART #
P04-0004-L
P04-0004-R
P04-0005
P04-0006
DA1C03807716NU
DA1C03809316NU
DC120010510U
KEY
1
2
3
4
5
6
7
QTY
1
1
1
1
6
8
22
KEY
8
9
10
OR
11
12
PART #
P05-0009
DB2E03807200NU
P06-0021
P06-0021
P07-0002
P07-0003
DESCRIPTION
3/8”RHWASHER
3/8”LOWHEIGHTLOCKNUT
WHITERHCAP
PLATINUM RH CAP
BACKPAD
ARM PAD
QTY
22
8
22
22
1
2
DESCRIPTION
LEFTFRAME
RIGHTFRAME
BACKSUPPORT
CROSSSUPPORT
3/8X77mmBOLT
3/8X 93mmBOLT
3/8”SAEWASHER
BOLT LENGTH
Tools Required forAssembly
2
NOTE:BOLTLENGTHIS MEASUREDFROMTHE UNDERSIDE OFTHE HEAD OFTHEBOLT.
Bolt Length Ruler
* 9/16” wrench
* Ratchet with 9/16” socket
01
1/2 1/2 1/2 1/2 1/2 1/2
23456
10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
You must add ACU to each part number to connote that the part is an 
Acufit produced part. Example; ACUP04-0006 This is the Cross support 
weldment.

3
5 3/8X77mmBOLT 9
3/8” LOW
HEIGHT LOCK
NUT
7
3/8” SAE
WASHER
10
RH CAP
(WHITE/PLATINUM)
8
3/8” RH WASHER
6 3/8X93mmBOLT

STEP 1:
FIGURE 1
4
• SECURELY assemble the BACK SUPPORT (3) and the CROSS SUPPORT (4) to the LEFT and RIGHT FRAME (1 & 2) using
sixteenRH CAPS (10),eight 3/8 X93mm BOLTS(6), sixteen 3/8”SAEWASHERS (7), sixteen 3/8”RHWASHERS (8) andeight 3/8”
LOWHEIGHTLOCKNUTS(9)asshowninFIGURE1.
6 3/8X 93mm
4
3
2
1
8 7 10
9

STEP 2:
FIGURE 2
5
• SECURELY assemble theBACK PAD(11) to the BACKSUPPORT(3) usingtwo RH CAPS (10),two 3/8 X77mmBOLTS (5),two
3/8” SAE WASHERS (7) and two 3/8” RHWASHERS (8) as shown in FIGURE 2.
• SECURELYassemble twoARMPADS(12) to theLEFTandRIGHTFRAMES(1 & 2)using four RH CAPS(10), four 3/8X 77mm
BOLTS (5), four 3/8” SAE WASHERS (7) and four 3/8” RH WASHERS (8) as shown in FIGURE 2.
5 3/8X 77mm
11
3
2
1
8
10
12
7
SERIAL #
LOCATION

Clean:
• Upholstery with mild soap and water.
• Guide rods with a cotton cloth.
• Hand grips with mild soap and water.
• Frame damage can be repaired with touch-up paint can be purchased from your LifeFitness customer service representative at
[phone].
Inspect:
• Cables for wear or damage and proper tension (should not exceed 3/4” deflection.) Pay close attention at bends and attachment
points.
• Hardware should be checked for looseness. Tighten as required.
• Frames should be inspected for wear or damage.
• Hand Grips should be checked for wear or damage
Lubricate:
• Lube the Guide Rods. Apply the lubricant to a cotton cloth, then run the cotton cloth up and down the guide rods as needed. Do not
spray lubricant directly on the Guide Rods.
PREVENTATIVE MAINTENANCE TIPS
There is a risk assumed by individuals who use this type of equipment. To minimize risk, please
follow these rules:
2. Do not allow minors or children to play on or around this equipment.
1. Inspect equipment daily. Tighten all loose connections and replace worn parts immediately.
Failure to do so may result in serious injury.
3. Exercise with care to avoid injury.
4. Consult your physician before beginning any exercise program.
6
Thankyou forpurchasingtheLifeFitnessCLUBSERIESVERTICALKNEE RAISE.If unsureofproper
useofequipment, call your localLifeFitness distributor or call the LifeFitnesscustomer service depart-
ment at [phone].
CAUTION-PLEASE READ
Action DAILY WEEKLY QUARTERLY BI-ANNUALLY AS NEEDED
CLEAN
Upholstery X
Guide Rods X
Hand Grips X
INSPECT
Visual Overall X
Cables X
Hardware X
Frame X
Hand Grips X
LUBRICATE
Guide Rods X
WARRANTY INFORMATION
10YEARS STRUCTURUALFRAME
3 YEARS PILLOWBLOCKS,PULLEYS,WEIGHTPLATESAND GUIDE RODS
1 YEAR CABLES
90 DAYS UPHOLSTERY