Lightmybricks 75306 User manual

LEGO® IMPERIAL PROBE DROID
#75306 LIGHT KIT
INSTALLATION GUIDE

LEGO IMPERIAL PROBE DROID 75306 LIGHT KIT INSTALL GUIDE
2
Light My Bricks
LEGO® IMPERIAL PROBE DROID
#75306 LIGHT KIT
INSTALLATION GUIDE
Hi There!
We’re here to help you get started on the LEGO®
Imperial Probe Droid (75306) Light Kit.
This PDF details the instructions for the LED light kit only.
If you run into any issues, please refer to the
troubleshoot-ing section towards the end of this guide.
Have fun and enjoy!
INSTALLATION GUIDE

LEGO IMPERIAL PROBE DROID 75306 LIGHT KIT INSTALL GUIDE
PACKAGE CONTENTS 3
PACKAGE CONTENTS: LEGO PIECES:
1 x Flashing Red 30cm Bit Light
1 x Red 30cm Bit Light
2 x Orange 30cm Bit Light
1 x White 15cm Bit Light
1 x Cool White 15cm Bit Light
1 x Cool White 30cm Bit Light
2 x 6-Port Expansion Board
2 x Adhesive Squares
•2 x Slope 30 1 x 1 x 2/3 - Trans Clear
•2 x Round Plate 1 x 1 - Trans Red
•1 x Round Plate 1 x 1 - Trans Orange
•1 x Round Plate 1 x 1 - Trans Clear
1 x 30cm Connecting Cable
1 x USB Power Cable
(Power Source not Included)

LEGO IMPERIAL PROBE DROID 75306 LIGHT KIT INSTALL GUIDE
CONTENTS 4
Contents
Before You Begin 5
Instructions 8
Final Product 19
Troubleshooting 20
Contact 25

LEGO IMPERIAL PROBE DROID 75306 LIGHT KIT INSTALL GUIDE
BEFORE YOU BEGIN 5
Before You Begin
Laying cables in between
and underneath bricks
Cables can fit in between and underneath
LEGO® bricks, plates, and tiles providing
they are laid correctly between the
LEGO® studs. Do NOT forcefully join
LEGO® together around cables; instead
ensure they are laying comfortably in
between each stud.
CAUTION: Forcing LEGO® to connect over
a cable can result in damaging the cable
and light.
Connecting Cable
Connectors To Expansion
Boards
Take extra care when inserting connectors
to ports of Expansion Boards. Connectors
can be inserted only one way. With the
expansion board facing up, look for the
soldered “=” symbol on the left side of the
port. The connector side with the wires
exposed should be facing toward the
soldered “=” symbol as you insert into the
port. If a plug won’t fit easily into a port
connector, do not force it.
Incorrectly inserting the connector can
can result in bent pins inside the port or
possible overheating of the expansion
board when connected.