Lightmybricks 76209 User manual

LEGO® THOR’S HAMMER #76209
LIGHT KIT
INSTALLATION GUIDE

LEGO THOR’S HAMMER 76209 LIGHT KIT INSTALL GUIDE
2
Light My Bricks
LEGO® THOR’S HAMMER #76209 LIGHT KIT
INSTALLATION GUIDE
Hi There!
We’re here to help you get started on the LEGO®
Thor’s Hammer (76209) Light Kit.
This PDF details the instructions for the LED light kit only.
If you run into any issues, please refer to the
troubleshoot-ing section towards the end of this guide.
Have fun and enjoy!
INSTALLATION GUIDE

LEGO THOR’S HAMMER 76209 LIGHT KIT INSTALL GUIDE
PACKAGE CONTENTS 3
PACKAGE CONTENTS: ASSORTED BRICKS:
1x White 15cm Bit Light
1x Warm White Large 15cm Bit Light
14x Blue 15cm Bit Light
11x Cool White Large 15cm Bit Light
1x 6-Port Expansion Board
2x 8-Port Expansion Board
1x 12-Port Expansion Board
•4 x Dark Grey Plate 2x2
•9x Dark Grey Tile 1x2
•2x Tile 1x1 W Clip Round Edges - Black
•3x Plate 1x1 Mod Rounded w Handle - Black
•4x Round Plate 1x1 Open Stud - Black
•1x Arm Skeleton, Bent with Clips (Horizontal Grip) - Black
•1x Plate 1x2 MW Bar Handle on Side - Black
1x NO Push Board
1x Scary Eects Board
1x Flicker Eects Board
6x 5cm Connecting Cable
1 x USB Power Cable
(Power Source not Included)
* Spares included

LEGO THOR’S HAMMER 76209 LIGHT KIT INSTALL GUIDE
CONTENTS 4
Contents
Before You Begin 5
Blueprint 8
Instructions 9
Final Product 35
Troubleshooting 36
Contact 41

LEGO THOR’S HAMMER 76209 LIGHT KIT INSTALL GUIDE
BEFORE YOU BEGIN 5
Before You Begin
Laying cables in between
and underneath bricks
Cables can fit in between and underneath
LEGO® bricks, plates, and tiles providing
they are laid correctly between the
LEGO® studs. Do NOT forcefully join
LEGO® together around cables; instead
ensure they are laying comfortably in
between each stud.
CAUTION: Forcing LEGO® to connect over
a cable can result in damaging the cable
and light.
Connecting Cable
Connectors To Expansion
Boards
Take extra care when inserting connectors
to ports of Expansion Boards. Connectors
can be inserted only one way. With the
expansion board facing up, look for the
soldered “=” symbol on the left side of the
port. The connector side with the wires
exposed should be facing toward the
soldered “=” symbol as you insert into the
port. If a plug won’t fit easily into a port
connector, do not force it.
Incorrectly inserting the connector can
can result in bent pins inside the port or
possible overheating of the expansion
board when connected.