Lippert Components Sliding Swivel Seat Base User manual

Sliding Swivel Seat Base
Owner's Manual

Rev: 05.09.19 Page 2 CCD-0001601
TABLE OF CONTENTS
System Information 2
Safety 2
Swivel and Slide Operation 3
Drive Position 3
Maintenance 3
System Information
The Sliding Swivel Seat Base allows the user to slide the seat base out at a 45° angle, so that the seat can be
swiveled 180°. There are five models of the seat base available for the vehicles listed below.
NOTE: There are slight differences in appearance between the different models, but they all function the
same as the model shown.
Safety
This manual provides general instructions. Many variables can change the circumstances of the intended
instructions, i.e. the degree of difficulty involved in the service operation and the ability of the individual
performing the operation. This manual cannot begin to plot out instructions for every possibility, but will
provide the general instructions, as necessary, for operating and servicing the device, product or system.
In the event the skill level required is too advanced or the procedure too difficult, a certified technician
should be consulted before performing the necessary service. Failure to correctly perform a troubleshooting
procedure may result in voiding the warranty, inflicting personal injury or death.
The "WARNING" symbol above is a sign that a procedure has a safety risk involved and may cause death
or serious personal injury if not performed safely and within the parameters set forth in this manual.
Failure to follow instructions provided in this manual may result in death, serious personal injury
and/or severe product and property damage, including voiding of the component warranty.
The "CAUTION" symbol above is a sign that a procedure has a safety risk involved that may cause
personal injury and/or product damage, including voiding of warranty, if not performed safely and
in accordance with the safety procedures stated herein.
Moving parts can pinch, crush or cut. Keep clear and use caution.
Part Number Vehicles and Seat
696038 Ford CLS C (Driver Side)
696039 Ford CLS C (Passenger Side)
670698 Freightliner (Driver Side)
670699 Freightliner (Passenger Side)

Rev: 05.09.19 Page 3 CCD-0001601
The seat slide lever that operates the Swivel Slide Seat Base is on the right side (curbside) of the driver seat
and on the left side (roadside) of the passenger seat.
1. Pull the seat slide lever up (Fig. 1) to slide the seat base from its original position towards the center of
the vehicle at a 45 degree angle (Fig. 2).
NOTE: Driver side seat base shown.
Front
Rear
Roadside Curbside
Do not attempt to operate the Swivel Seat Base while the vehicle is motion.
Swivel and Slide Operation
Fig. 1 Fig. 2
2. After the slide mechanism has clicked into place, the seat can be rotated up to 180 degrees from the
forward-facing position.
Drive Position
Seat Slide
Lever Seat Base Out at 45 Degree Angle
To return to a driving position:
1. Swivel the seat back to the forward-facing position.
2. Pull up on the seat side lever (Fig. 1) and slide the seat back to the drive position until it clicks into place.
Maintenance
There are no servicable parts in the Sliding Swivel Seat Base.
Swivel seat base must be locked into the foward-facing position before putting vehicle into motion.

The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”).
LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an
authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty.
The information contained in this manual is subject to change without notice and at the sole discretion of LCI.
Revised editions are available for free download from lci1.com.
Please recycle all obsolete materials.
For all concerns or questions, please contact
Lippert Components, Inc.
Ph: [phone] | Web: lci1.com | Email: [email protected]