LYSON Vap-Pro Diffusor 12V User manual

Manual
Vap-Pro
Diffusor 12V
Przedsiębiorstwo Pszczelarskie Tomasz Łysoń
Spółka z o.o. Spółka Komandytowa
34-125 Sułkowice, ul. Racławicka 162, Polska
www.lyson.com.pl, email: [email protected]
tel.[phone]Siedziba Firmy Klecza Dolna 148 ,34-124 Klecza Górna

D12V
Manual device
1. General safety rules for using the device
1.1 Terms of use
1.2. Electrical safety
1.3. Safety of use
2. Characteristics of the device
2.1. Device description
2.2. Description of the SPK-1 temperature controller
2.3. Technical parameters
3. Storing the device
4. Maintenance and cleaning
5. Disposal
6. Warranty

GENERAL PRINCIPLES OF DEVICE SAFETY
Prior to device usage initiation, refer to the following
manual and act according the guidelines contained
therein. The manufacturer shall not be held accountable
for any damages caused by improper usage of the device
or its improper handling
1.1 .OPERATING PRINCIPLES
1. The sublimator is a device for the evaporation of oxalic
acid. It is powered by 12V DC.
2. Before starting the treatments, you must absolutely put
on the protective clothes (protective glasses, rubber
gloves, gas mask)
1.2. ELECTRICAL SAFETY
1. If the power cord is damaged and needs to be replaced,
this operation should be performed at the guarantor's or
by a specialized repair facility or by a qualified person.
Do not use the device if the connecting cable is damaged!
2. It is forbidden to pull the connection cable.
The cable should be kept away from heat sources, sharp
edges and its good condition.
1.3.OPERATING SAFETY
The following equipment is not intended to be used by
persons with limited physical, sensory or mental capabili-
ties (including children) or persons inexperienced or unfa-
miliar with that type of equip-ment unless the usage oc-
curs under supervision or in line with the equipment oper-
ating manual provided by safety supervising persons.
Make sure that chil-dren do not play with the device
2. If the device cable gets damaged, the rep airs mustbe
performed solely by a specialized repair centreor by a
qualified person in order to avoid any threat
3. It is forbidden to perform any maintenance works when
the device is in
4.WARNING:
-the device heats up to high temperatures!
- oxalic acid is corrosive
-acid vapors are irritating to the skin, eyes and respiratory
system
- wear protective clothing against burns (gloves, protective
suit)
-use a mask protecting the respiratory tract and goggles
- oxalic acid should be stored in a sealed, labeled container
2. Characteristics of the
device
Oxalic acid sublimator is used to control warroa destructor
in bee colonies. For optimal treatment, the temperature
outside the hive should be around 10 ° C.
The sublimator is ready to use right after taking it out of
the suitcase, just connect the device to a 12V power
source. The device has a profiled inside cover (2) of the
heating head, into which we pour about 2g. oxalic acid.
The set includes two lids (2) and a measuring cup.
USING THE DEVICE
- remove the cover (2) from the heating head (3)
- connect the sublimator to the battery and wait for
the green and red diodes on the controller to light up
permanently
- we close the sublimator with a lid with oxalic acid

- put the nozzle (1) to the inlet hole in the bottom for
about 2 minutes.
2.1 Description of the device
1 2 3 4 5 6
1-acid outlet nozzle
2-cover of the heating head
3-heating head
4-SPK-1 control
5-clamps battery
6-fuse 20A
2.2 Description of the controller
2.3 Technical parameters
-heater power: 160W
- supply voltage: 12V / 20A
-stabilized temperature: 220 ° C (± 10 ° C)
-automatic shutdown: after 45 min.
- power cord: 1.5 m
-Dimensions: L 430 x W 160 x H 80 mm.
-weight:
3. Device storage
After finishing work, the device should be thoroughly
cleaned. Store in dry rooms. Before each season, an
additional technical inspection should be made and in the
event of a defect being found, the service should be
contacted.
4. Maintenance and cleaning
After finishing work, the device should be thoroughly
cleaned. Store in dry rooms. Before each season, an
additional technical inspection should be made and in the
event of a defect being found, the service should be
contacted.
5.RECYCLING
Worn-out product must be removed as waste only within
selective waste collection organised by the Network of
Communal Electric and Electronic Waste Collecting Points.
A customer is entitled to return the used equipment to
the electrical equipment distributor network, at least free
of charge and directly, if the device to be returned is of
proper type and serves the same purpose as the newly
purchased device
6.GUARANTEE
The products purchased in “Łysoń” company are encom-
passed by the manufacturer’s guarantee.
The guarantee period equals 2 years
A receipt or a VAT invoice is issued for each product pur-
chased.
Guarantee terms details, see www.lyson.com.pl