Madison Park Colfax User manual

ASSEMBLY INSTRUCTIONS
Description: Colfax Counter & Bar Stool
Important safety instructions :
• Please read carefully all instructions before assembly.
• For your safety and ease, assembly by two or more adults is recommended.
• Keep instructions for future use.
Pre-assembly:
• Do not discard any contents until assembly is complete to avoid accidentally discarding small parts or
hardware.
• Remove all parts and hardware from box along with any plastic protective packaging.
Parts List
QTY
1
1
1
1
1
2
Hardware List
QTY
4
5
9
9
1
6
DISCLAIMER :
WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE.
SELLER IS NOT LIABLE FOR ANY DAMAGES RESULTING FROM ITEM BEING IMPROPERLY ASSEMBLED
AFTER PURCHASE.
Page 1 of 3
P5
Right Stretcher
Front Stretcher
Item
P1
P2
P3
P4
Description
Long Bolts Ø5/16" x 3"
Description
Stool Back
Seat Cushion
Left Stretcher
P6
Front Legs
H2
Short Bolts Ø5/16" x 2"
Item
H1
H5
H6
H3
Allen Wrench 5/16"
Screw #8 x 1-1/2"
Lock Washers 5/16"
H4
Flat Washers 5/16"

Assembly Procedures:
Step 1.
Asemble the stool on a flat,soft surface such as carpet or cloth to prevent scratching the finish.
Attach seat cushion (P2) to stool back (P1) using bolt (H2), lock washer (H3) and flat washer (H4). Loosely tighten
the bolts with Allen wrench (H5).
Step 2:
Attach seat cushion (P2) to stool back (P1) using bolts (H1), lock washers (H3) and flat washers (H4).
Loosely tighten the bolts with Allen wrench (H5) .
Page 2 of 3

Step 3:
Insert right stretcher (P4) to the leg of stool back (P1) according to the label "R" on the leg of stool back and the
front end of right stretcher (P4). Loosely attach frontleg (P6) to the bottom of seat cushion (P2) and right stretcher
(P4) using bolt (H2), lock washer (H3),flat washer (H4) and Allen Wrench (H5).Do not tighten the screws at this
time .
Step 4 :
1) Insert left stretcher (P3) to the leg of counter stool back (P1) according to the label "L" on thelegs of stool back and
the front end of left stretcher (P3). Loosely attach the frontleg (P6) to the seat cushion (P2) using bolt (H2).lock
washer (H3),flat washer (H4) and Allen Wrench (H5). Do not tighten the screws at this time.
2) Insert the front stretcher (P5) between the frontlegs .
3) Securely tighten all bolts, but do not over tighten the bolts .
4) Tighten all screws (H6) through the stretcher (P3 ,P4,P5) to the frontlegs and stool back legs with screw driver
(not provided ).
5) Assembly is complete.
THANK YOU FOR YOUR PURCHASE
Page 3 of 3
ADDITIONAL NOTE ABOUT SAFETY :
BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE.
THEY SHOULD BE INSPECTED AT LEAST EVERY 3 MONTHS AND RE-TIGHTENED AS NEEDED TO PREVENT DAMAGE OR INJURY AND ENSURE STABILITY.