Madison Park Bryce User manual

Important safety instructions
• Please read carefully all instructions before assembly.
• Keep instructions for future use.
Pre-assembly
• Remove all parts and hardware from box along with any protective packaging.
Parts List
Item QTY
P1 Seat 1
P2 Back Support 1
P3 Top Stretcher 1
P4 Bottom Stretcher 1
P5 Left Base 1
P6 Right Base 1
Hardware List
Item QTY
H1 Short Bolt
(M6x10mm) 6
H2 Long Bolt
(M6x60mm) 4
H3
Allen Wrench
M6
4
ASSEMBLY INSTRUCTIONS
Bryce Counter Stool
Description
• Do not discard any content until assembly is completed to avoid accidentally discarding small parts or hardware.
Description
DISCLAIMER:
WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE. SELLER IS NOT LIABLE FOR ANY DAMAGESRESULTING
FROM ITEM BEING IMPROPERLY ASSEMBLED AFTER PURCHASE.
Assembly Procedures:
Step 1. Assemble the chair on a flat, soft surface such as a carpet or cloth to prevent scratching.
Connect the bottom stretcher(P4) to the left and right base (P5&P6),loosely tighten the four bolts(H1) with the allen wrench(H4) as below.
Page 1 of 4
H4
Short Bolt
(M6x15mm)
1
P5
P6
P4
P5
P6
P4
H4
H1
P5

Page 2 of 4
Step 2.Put down the back support(P2) to connect the base, loosely tighten the two bolts(H1) with allen wrench(H4) as below.
Step 3. Connect the top stretcher(P3) to the base frame as below.
P6
P2
P5
P4
P3
P5
P4
P6
P2
(H4)
(H1)
P6
P5
P4
P2

Page 3 of 4
Step 4.Fully tighten the four bolts(H3) with allen wrench(H4).
Step 5. Turn over the chair seat (P1) and fully tighten long bolts (H2) with allen wrench (H4).
P6
P2
P4
P5
P3
H4
H3
(P1)
100%
(H4)
(H2)

Page 4 of 4
Step 6.Use an Allen wrench (H4) to completely tighten the remaining bolts.
Step 7. Assembly is complete. Failure to follow these instructions may cause the bolts to misalign during asssembly.
Leveler adjustment: Levelers are pre-installed on the legs. Adjust as needed to make sure the chair is level.
Thank you for your purchase
ADDITIONAL NOTE ABOUT SAFETY:
BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE.
THEY SHOULD BE INSPECTED AT LEAST EVERY 3 MONTHS AND RE-TIGHTENED AS NEEDED TO PREVENT DAMAGE OR INJURY,
AND ENSURE STABILITY.
Adjustable leveler
100%
(H4)