Marcy JX-7301 Installation and operating instructions

NOTE:
Please read all
instructions carefully
before using this product
Table of Contents
Safety Notice
Hardware Pack
Assembly Instruction
Parts List
Warranty
Ordering Parts
Model
JX-7301
Retain This
Manual for
Reference
210311
ASSEMBLY &
OWNER’S
MANUAL
DUAL ACTION RECUMBENT
BIKE
JX-7301
IMPEX®INC.
2801 S. Towne Ave. Pomona, Ca 91766
Tel: [phone] Fax: [phone]
www.marcypro.com
[e-mail]

1
TABLE OF CONTENTS
BEFORE YOU BEGIN
1
IMPORANT SAFETY NOTICES
2
WARNING LABEL PLACEMENT
3
HARDWARE PACK
4
COMPONENT FOR ASSEMBLY
5
CARE AND MAINTENANCE AND STORAGE
6
EXPLODED DIAGRAM
7
PARTS LIST
8
ASSEMBLY STEPS
10
EXERCISE GUIDELINES
20
WARRANTY
22
ORDERING PARTS
22
BEFORE YOU BEGIN
Thank you for selecting the MARCY Dual Action Recumbent Bike by
IMPEX®INC. For your safety and benefit, read this manual carefully before
using the bike. As a manufacturer, we are committed to provide you
complete customer satisfaction. If you have any questions, or find there are
missing or damaged parts, we guarantee you complete satisfaction through
direct assistance from our factory. To avoid unnecessary delays, please
call our TOLL-FREE customer service number. Our Customer Service
Agents will provide immediate assistance to you.
Toll-Free Customer Service Number
1-800-999-8899
Mon. - Fri. 9 a.m. - 5 p.m. PST
www.marcypro.com
[e-mail]

2
IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise bike is built for optimum safety. However, certain precautions apply
whenever you operate a piece of exercise equipment. Be sure to read the entire
manual before you assemble or operate your bike. In particular, note the following
safety precautions:
1. Keep children and pets away from the exercise bike at all times. DO NOT
leave children unattended in the same room with the bike.
2. Only one person at a time should use the bike.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.
4. Position the bike on a clear, leveled surface. DO NOT use the bike near water or
outdoors.
5. Keep hands away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear robes or
other clothing that could become caught in the bike. Running or aerobic shoes are
also required when using the bike.
7. Use the bike only for its intended use as described in this manual. DO NOT use
attachments not recommended by the manufacturer.
8. Do not place any sharp object around the bike.
9. Disabled person should not use the bike without a qualified person or physician in
attendance.
10. Before using the bike to exercise, always do stretching exercises to properly warm
up.
11. Never operate the bike if it is not functioning properly.
12. Read all warnings posted on the exercise bike.
13. Inspect the exercise bike for worn or loose component prior to use. Tighten/replace
any loose or wore components prior to use.
14. Care should be taken in mounting or dismounting the exercise bike.
15. This exercise bike is for consumer and home use only.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE
AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL
INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC.
ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY
DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.

3
WARNING LABEL PLACEMENT
The Warning Labels and Caution Label shown here have been placed on the Rear
Stabilizer and Main Frame.
If the labels are missing or illegible, please call customer service at 1-800-999-
8899 for replacement. Apply the labels in location shown.

4
HARDWARE PACK

5
COMPONENTS FOR ASSEMBLY

6
CARE, MAINTENANCE AND STORAGE
1. Inspect and tighten all parts each time you use the bike. Replace any worn parts
immediately.
2. The bike can be cleaned using a damp cloth and mild non-abrasive detergent. Do
not use solvents.
3. Store the bike IN-DOOR. Excess moisture and water would cause rust on the
frame.
4. The Bike shall be placed at least 24 inches away from the wall or/and any other
object such as furniture to provide safe access to and passage around the bike.
5. To avoid possible injury, the help of two or more people is needed when moving the
bike around.
6. Disposal Instructions – The equipment can be safely disassembled and disposed
without unreasonable hazards. Call your local recycle agency regarding details of
recycling.
7. The maximum user weight is 300 lbs.
8. Assembled Dimension: 61”x26.75”x47.25

7
EXPLODED DIAGRAM

8
JX-7301 PARTS LIST
Part #
Description
Size
Qty
1
Main Frame
1
2
Rear Frame
1
3
Rear Stabilizer
1
4
Front Stabilizer
1
5
Front Post
1
6
Left Lower Swing Arm
1
7
Right Lower Swing Arm
1
8
Seat Support
1
9
Seat Adjustment Assembly
1
10
Linkage Arm
2
11
Right Upper Swing Arm
1
12
Left Upper Swing Arm
1
13
Seat Pad
1
14
Backrest Pad
1
15
Plastic Sleeve
2
16
Carriage Bolt
M8x2½”
4
17
Curved Washer
12
18
Locking Washer
32
19
Acorn Nut
M8
8
20
Lever Sleeve
1
21
Allen Bolt
M8x⅔”
30
22
Washer
30
23
Crank
1
24
Spacer
1
25
End Cap
2
26
Leveler End Cap
2
27
Roller End Cap
2
28
Seat Rail
1
29
Hex Bolt
4
30
Seat Support End Cap
2
31
Leveler
1
32
Left Crank Hex Nut
1
33
Right Crank Hex Nut
1
34
Large Washer
Φ ⅔”
2
35
Pedal Spacer
2
36
Wave Washer
Φ ⅔”
2
37
Water Bottle Holder
1
38
Left Pedal
1

9
39
Right Pedal
1
40
Tension Knob
1
41
Threaded End Cap
2
42
Swing Arm Sleeve
2
43
Swing Arm End Cap
2
44
Handlebar Grip
2
45
Computer
1
46
Phillips Screw
M5×½”
4
47
Right Shroud
1
48
Left Shroud
1
49
Allen Bolt
M6x½”
4
50
Locking Washer
Φ ¼”
7
51
Washer
Φ ¼”
2
52
Connecting Rod
2
53
Wave Washer
Φ ½”
2
54
Self-tapping Screw
ST4.8×½”
2
A2/B1
Computer Wire
1
B2
Sensor Wire
1

10
ASSEMBLY STEP 1

11
ASSEMBLY STEP 2

12
ASSEMBLY STEP 3

13
ASSEMBLY STEP 4

14
ASSEMBLY STEP 5

15
ASSEMBLY STEP 6

16
ASSEMBLY STEP 7

17
ASSEMBLY STEP 8

18
ASSEMBLY STEP 9

19
Operating Notes
•To adjust seat position, pull up on lever (#9) to disengage lock, move to desired
position, push down on lever to lock.
•To adjust resistance, turn resistance knob (#40) clockwise to increase resistance,
counter-clockwise to reduce resistance.
•To adjust the leveler (#31), turn/twist the leveler knob to increase and decrease
height to ensure the bike is level.