Marcy ME-702 User manual

REGENERATING
MAGNETIC UPRIGHT BIKE
ME-702
Distributed By:
Pure-Tec Limited
www.puretecfitness.com
www.puretecfitness.com

www.puretecfitness.com
1
HARDWARE PARTS LIST
No.
Description
Drawing
Q’ty
11
Quick release knob
1
15
Allen screw M8 x 2"
4
16
Curved washer Φ8Φ22
12
18
Allen screw M8 x ⅝"
8
19
Lock washer
4
Box wrench
1
Allen key L6
1
Above described parts are all the parts you need to assemble this machine. Before you start
to assemble, please check the hardware packing to make sure they are included.

www.puretecfitness.com
2
STEP 1
Attach the front stabiliser (#2) with Allen screw (#15), lock washer (#19), and curved washer (#16) to the
main frame (#1).
Attach the rear stabiliser (#3) with Allen screw (#15), lock washer (#19) and curved washer (#16) to the
main frame (#1).
215 16
15
16 19
19
1
3

www.puretecfitness.com
3
STEP 2
Pull up the ring (#32) and the cover for the front post (#38) and connect the middle computer wire (#33)
to lower computer wire (#34).
Tighten the front post (#4) with curved washer (#16) and Allen screw (#18).
38
33
16
18 18
16
16
4
1
34
34
33
32

www.puretecfitness.com
4
STEP 3
Connect the middle computer wire (#33) and hand pulse wire middle (#20) to the console (#6) and attach
the console to the front post (#4) with screws(#27). The screws are pre-assembled on the computer.
Attach handle bars (#5 and #21) to the front post (#4) with curved washer (#16) and Allen screw (#18).
1
4
6
18
16 5
20
20
1618
21
33

www.puretecfitness.com
5
STEP 4
Secure the seat post cover (#12) to the seat post (#7) with self-tapping screw (#40).
Insert the seat pad (#8) to the front of the seat post and secure the bolt from two sides.
Put the seat post (7) into the cover for seat post (#17). Insert the seat post (#7) into main frame (#1),
line up the holes and secure the seat in position with the quick release knob (#11).
The correct height for the seat can be adjusted after the bike is fully assembled.
1
11
7
8
12
17
40

www.puretecfitness.com
6
STEP 5
Attach the left and right pedal (#9 and #10) to the left and right crank (#48 and #49).
Note: the pedals are marked with "R" and "L". The right pedal (R) should be threaded on clockwise and
the left pedal (L) should be threaded on counter-clockwise.
1
9
10
48