MedaCure CB1000 User manual

Bariatric Commode
Weight Capacity: 1,000 lbs.
Model # CB1000
Medacure Inc.
545 N. Arlington Avenue
East Orange, NJ 07017, USA
www.medacureinc.com
Medacure
Limited Warranty
The MedaCure Bariatric Commode is guaranteed to
be defect-free in materials and workmanship for one
(1) year from the date of purchase.
Damages that are not covered by this warranty
include defects due to misuse, abuse or negligence
and normal wear and tear on the device. This
warranty does not include or extend to non-durable
components, (i.e., rubber accessories, casters, and
grips), as they need periodic replacement due to
normal wear.
For questions about your MedaCure device and/
or the warranty, feel free to contact an authorized
MedaCure dealer.
© 2020 MedaCure Inc. All rights reserved.
MedaCure is a registered trademark of Medacure Inc.
East Orange, NJ 07017. Made in China.

Assembly Instructions &
Safety Precautions
Assembling Commode Seat & Lid
Adjusting Leg Height
Safety and Warnings
FIGURE #1
FIGURE #2
1. If exposed to the cold, allow toilet seat and lid to
come to room temperature before assembling to
prevent cracks from forming in the seat and lid
clamps during assembly.
2. Align the toilet seat clamps onto the back frame
rail, making sure that both clamps sit outside the
pail brackets. Apply pressure to the seat so that
the clamps snap into place rmly.
3. Slide the pail in from front of commode.
1. Adjust height of legs to your specic needs before use,
ensuring that all legs are at set to the same height. Lock
legs into place by aligning buttons into proper holes
(see gure 2).
2. Push down on or pull on legs to be ensure legs are
locked into place.
1. Toilet seat must be in down position before use to
avoid breakage of commode and possible injury.
2. Please read and understand this assembly and
instruction sheet before installing commode. Contact
a healthcare professional, dealer or technician before
if you do not understand these instructions before
attempting to install to avoid injury or damage.
3. Carefully review all parts for shipping damage prior
to assembly. Do not use if there has been shipping
damage. For further directions, contact dealer/carrier.
4. Be sure that the height adjusting snap buttons fully
extend through the same respective hole of each leg
extension to secure the leg extensions rmly position
and a uniform height is set (see Figure 1).
5. Ensure ALL screws, nuts and/or bolts are fully tightened.
6. Inspect leg extension rubber tips for rips and wear and
make sure none are missing. If rips or wear are found,
immediately replace the tips.
7. Make sure all four leg extensions with rubber tips
continuously touch the oor simultaneously.
8. Supervise or assist users with limited physical strength
while using this product.
9. Arm supports should be used for assistance only. Arms
should not be used to support full body weight.
10. Unlatch and drop arms to assist in user onto/off of the
commode.