MegaLite ARFlood User manual

USER MANUAL
Table of Contents
Safety Information……………………………………………………………………………………………. 3
Specifications……………………………………………………………………………………………………..4
Main Power Connection…………………………………………………………………………………..5
DMX-512 Connection…………………………………………………………………...……………......5
Rigging the Fixture…………………………………………………………………………………………….6
Main Control Menu.......................................................................................................... 6
DMX Profile......................................................................................................................... 6
Cleaning & Maintenance...............................................................................................7
Parts List.............................................................................................................................. 7

Check that the unit has not been damaged during transport
Protection Against Fire
1. Maintain a minimum of 1 foot distance from any type of flame.
3. Replace fuse only with the specified type and rating.
4. Do Not install the unit to close to a heat source.
5. Make sure cable are properly secured away from unit movement.
Protection Against Fire
1. Disconnect power before servicing.
2. For connection to main power supply proceed to page 5.
3. This unit must be earthed. (electronically grounded)
Protection Against Mechanical Hazards
1. Use safety chain when hanging unit.
2. Use quality clamps or bolts when positioning unit
3. Do not open unit while it is on, risk of electrical shock.
3

4
Part Numbers
Fixture
4205–Arc Flood
Mechanical Specifications
Fixture Packaged for Shipping
Size: 13.5L x 3”W x 13 5/8”H
Weight: 12 lbs
Size: 15.5”L x 5”W x 13.75”H
Weight: 13lbs
DMX Connectors: 3-pin XLR IP connectors
Power Connection: Edison
IP Rating: IP 65
Display: Digital display
Fastening System: Mounting Yoke
Material: Die Cast aluminum
Electrical Specifications
LED Quantity: 48
Red: 16
Green: 16
Blue: 16
LED Watts: 1 watt
LED Manufacture: Bridge Lux
LED Lifetime: 60,000 to 100,000 hours
LED Angle: 130° x 60°( ± 5º )
Power Consumption: Universal 100 - 240V 50/60 Hz
Ballast: Electronic
Watts: 59
Amps: .81
Protocol: DMX 512
DMX Mode: 3 DMX channels R,G,B
Control & Programming
Specifications
10.75”
8.5”
13.5”3”

5
Main Power Connection
Caution!
1. Do not connect fixture to a dimmer system.
2. This unit has Auto switching power supply. It will respond to 110V or 220V automatically
3. This unit must be earthed. (electronically grounded)
4. Replace fuse only with the specified type and rating.
The occupation of the connection-cable is as follows:
1
2
3
1
3
2
DMX-512 Connection
110V Connection
The fixture is equipped with 3 pin XLR Sockets for DMX input and output. The sockets are wired in parallel. Only use a shielded
twisted pair cable designed for RS-485 and 3 pin XLR plugs and connectors in order to connect the controller with the fixture or
the fixture with another.
DMX—input DMX—output
1. Shield
2. Signal (-)
3. Signal (+)
Caution!
At the last fixture the DMX signal needs to be terminated with a terminator. Solder a 120
Ohm resistor between the (-) and the (+) signal into a 3 pin XLR plug and plug it in to the
last fixture on the signal run. Pre-manufactured terminator plugs are available for
purchase from your Mega-Lite dealer (HOS-DMXT).
Cable (USA) Cable (EU) Pin Connection
Black Brown
White
Green
Light Blue
Yellow/Green
Live
Neutral
Ground
L
N
Cable (USA) Cable (EU) Pin Connection
Black Brown
White
Green
Light Blue
Yellow/Green
Live
Live
L
N
220V Connection
LN