Memphis Shades 2321-0020 Datasheet

MEM8903 ’11-14-07’
2321-0020
VICTORY VEGAS 2004
SPORTSHIELD MOUNTING INSTRUCTIONS AND PARTS LIST
TOOLS REQUIRED: 3/16” Allen wrench (provided)
1. Install the mounting plates onto the windshield using the pre-assembled bolts on the mounting plates. The
Santoprene grommets should be inserted through the holes in the windshield so that the flat round part of
the grommet lays flat on both sides of the windshield. On each plate, get both tabs started before you
tighten them. (see Figure 1.1 & 1.2)
Note: Tabs point in towards each other.
2. Loosely install the four fork clamps on the forks, approximately 1 3/4" inches apart. (see Figure 2)
3. Loosen the four mounting bolts that are to hold the mounting plates to the fork clamps, and slide the
mounting plates onto the fork clamps. (see Figure 3)
4. Adjust the height, angle, and alignment of the shield. Carefully check gas tank clearance, and tighten all
mounting bolts.
WARNING: This is a quick change kit. ALWAYS tighten down all mounting bolts after removing or
installing the windshield.
Fig. 1.1 Left side plate Fig. 1.2 Right side plate Fig. 2 fork clamps Fig. 3 shows mounting of plates
WARNING
If the adjustable clamps are installed backwards, it may result in serious gas tank
damage. Always check for proper gas tank clearance before tightening hardware.
Care and Cleaning Instructions
To clean your windshield, use only warm water and a mild non-abrasive, dishwashing liquid. Use a soft cloth,
such as a T-shirt or flannel cloth. To protect your windshield, please use Novus #2 to remove minor scratches,
or use a polish like Memphis Shades Shinola which is specially designed for plastic windshields; glass cleansing
agents will cause severe damage to your windshield and will void your warranty.
Never use any glass products, petroleum based chemicals, or cleaning agents with ammonia, bleach or any harsh
chemicals. This includes Rain-X, brake fluid, acetone, and gasoline.

MEM8903 ’11-14-07’
2321-0020 MOUNTING KIT
VICTORY VEGAS 2004 SPORTSHIELD
PART # DESCRIPTION QTY.
M8903 MOUNTING INSTRUCTIONS/PARTS LIST 1
M1061 LEFT VEGAS MOUNTING PLATE 1
M1062 RIGHT VEGAS MOUNTING PLATE 1
M577 MED. INNER ADJ. FORK CLAMP 4
M578 MED OUTER ADJ. FORM CLAMP 4
M501 BEVELED SOCKET WASHER 4
M504 SOCKET SHOULDER WASHER 4
M505 BUTTON NUT 4
M543 SANTOPRENE GROMMET 4
M306 ¼” – 20 X 5/8” SS SCHCS 4
M301 1/4’’ – 20 x 3/8’’ SS SOCKET HEAD CAP SCREW 4
M302 1/4" - 20 X 1/2" SS SOCKET HEAD CAP SCREW 4
M310 3/16" SHORT ARM ALLEN WRENCH 1
M313 3/16” SHORT ARM ALLEN WRENCH COVER 1
M314 3/16” T-HANDLE ALLEN WRENCH 1
M337 3/16” T-HANDLE ALLEN WRENCH COVER 1
Memphis Shades warrants all product components, metal and plastic,
against defects in materials and workmanship for 24 months.
FOR PARTS AND WARRANTY HELP, CONTACT:
MEMPHIS SHADES
P. O. Box 429
Rossville, TN 38066
[phone]
Visit us on the web at www.memphisshades.com or
you can also reach us at
[email protected]