METHVEN 01-2732 User manual

Methven Australia Pty Ltd
ABN 15 104 813 390
Melbourne, Australia
www.methven.com
www.methven.com
SEPT 2011 MA012732
Minimalist Wall Mounted
Bath Set
01-2732
Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.
Damage caused by hydrostatic testing is not covered by our warranty.
IMPORTANT
Please read all of the instructions before installation
Installation Guide
WMKA 21005
SPEC001
Ceramic Cartridge Adjustment
Do not remove the ceramic cartridge from the body assembly while carrying
out the following adjustments. Note, the cartridge is factory set for maximum
temperature
-
+
-
+
Remove half-dome
(if attached)
Flow limiting adjustment
Mix temperature limiting
adjustment
1.5mm Allen Key

We recommend that this product is installed by a licensed plumber.
THE METHVEN GUARANTEE
The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methven.com
THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia
Technical Specifications
Avoid restrictive piping, fitting or sharp angled bends when plumbing the mixer.
The maximum working pressure of the ceramic cartridge is 1000kPa.
“In situ” testing
The maximum working pressure of the ceramic cartridge is 1000kPa. Do not
hydrostatic test the installation with this mixer installed. Damage to the ceramic
cartridge may occur, voiding our warranty.
Inlet Connections: All 1/2" BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.
Mixer Installation
Refer to diagram below and on the following page.
1. Remove the black plastic mixer protector but do not discard.
2. Secure the mixer body to the wall framing at the required position. Outlet port upwards.
3. Connect the hot and cold supplies to the mixer inlets marked H and C respectively. Connect
outlet.
4. Check the connections for leaks.
6. Remove and discard the black plastic mixer protector and screws only when the wall lining
and faceplate are to be fitted.
7. Slide faceplate over mixer until the faceplate is flush with the wall. Ensure the drain notch in
the face plate is at the bottom, care should be taken not to block the drain notch.
8. Fit the handle to the lever of the cartridge. Secure the handle in place by using the grub
screw provided.
Minimum 45mm
Maximum 70mm
Small
Faceplate
Wet Wall
Lining
Hole Cutout Ø102mm (4")
Diagram A
Handle
Assembly Faceplate
Body Assembly
Spout Installation
1. If required trim brass nipple to a length that allows outlet to pass through plate when
against wall
2. Fit faceplate to wall
3. Fit outlet to nipple