Metra Electronics 95-7333 User manual

INSTALLATION INSTRUCTIONS FOR PART 95-7333
95-7333
KIT FEATURES
•Double DIN Radio Provision
•Stacked ISO Mount Units Provision
• Painted To Match Factory
Bronze Dash
A) Double DIN Trim Plate B) Double DIN Brackets
Wiring & Antenna Connections (sold separately)
•70-7303 - Hyundai / Kia Harness 2009
•40-KI11 - Kia Antenna Adapter 2007-up
KIT COMPONENTS
A
Small Flat Blade Screwdriver • Panel Removal Tool
•Phillips Screwdriver
1-800-221-0932
©COPYRIGHT 2010 METRA ELECTRONICS CORPORATION
www.metraonline.com
TOOLS REQUIRED:
APPLICATIONS
HYUNDAI
Sonata 2009-10
B

Dash Disassembly
-HyundaiSonata2009-10.........................................1,2
Kit Assembly
-DoubleDINRadioProvision .......................................3
-Stacked ISO Mount Units Provision
Final Assembly ...........................................4
TABLE OF CONTENTS
95-7333
*Note:
Refer also to the instructions included with the aftermarket radio.

95-7333 DASH DISASSEMBLY
HYUNDAI SONATA2009 -10
A
B
1
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
Unclip and remove the shifter trim
panel. (Figure B)
3
Remove shifter knob from stem.
(Figure A)
2
Unclip and remove the (2) side trim
panels from the center console area.
(Figure C)
4
Continued on page 2.
C

95-7333 DASH DISASSEMBLY
HYUNDAI SONATA2009 -10
D
E
2
F
G
Remove (2) Phillips screws then
unclip and remove the small trim
panel below the factory climate con-
trols and above the pocket.
(Figure D,E)
5
Unclip and remove the trim panel sur-
rounding the radio and including the
climate controls and vents. (Figure F)
6
Remove (4) Phillips screws securing
the radio.Unplug and remove the
radio. (Figure G)
7
Continue to kit assembly.

3
95-7333 KIT ASSEMBLY
B
A
DOUBLE DIN/STACKED ISO MOUNT
UNITS PROVISION
Slide the Double DIN or stacked ISO
mount unit(s) into the bracket/trim
plate assembly and secure the
unit(s) to the assembly using the
screws supplied with the unit(s).
(Figure B)
2
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
Snap the Double DIN brackets to the
inside edge of the Double DIN trim
plate. (Figure A)
1