Metra Electronics 99-8223 User manual

APPLICATIONS
CAUTION: Metra recommends disconnecting the
negative battery terminal before beginning any
installation. All accessories, switches, and especially
air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition.
NOTE: Refer to the instructions included with the
aftermarket radio.
INSTALLATION INSTRUCTIONS FOR PART 99-8223
• A) Radio housing trim plate • B) Radio housing • C) Radio housing brackets • D) ISO Brackets
• E) ISO Trim plate
KIT COMPONENTS
• ISO DIN radio provision with pocket
• Painted to match factory dash
99-8223 = Black, 99-8223S = Silver
KIT FEATURES
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-1761 - Toyota harness 1987-up • TYTO-01 - LEX/TOY 2001-up amp interface
Antenna Adapter: • 40-LX11 LEX/TOY 2002-up into car
• Panel removal tool • Phillips screwdriver • Small flat blade screwdriver
TOOLS REQUIRED
Toyota Corolla 2009-2013
99-8223/99-8223S
A B C D E

99-8223
Dash Disassembly
1. Unclip and remove the (4) side trim
panels from the right and left side of the
radio and a/c controls. (Figure A)
2. Unclip and remove the a/c vent panel
above the factory radio. (Figure B)
3. Remove (4) 10 mm bolts securing the
radio. (Figure C)
4. Remove (8) screws securing the
brackets to the factory radio and remove
the brackets. Note, retain clips for re-
use during kit assembly. (Figure D)
5. Remove (4) plastic clips from the back
of the factory radio. Note, retain clips for
re-use during kit assembly.
(Figure A) (Figure B)
(Figure C) (Figure D)
REMOVE (4) SCREWS
FROM FACTORY BRACKET FROM EACH SIDE
Remove (4) screws from factory bracket
from each side

99-8223
Kit Assembly
ISO DIN radio provision with pocket
1. Attach the clips removed from the
factory radio to the back of the radio
housing trim plate. (Figure A)
2. Slide the radio housing brackets onto
the sides of the radio housing until the
side clips engage. Note, tabs are marked
Left and Right. (Figure B)
3. Mount the ISO brackets to the radio
using the screws supplied with the
radio. (Figure C)
4. Slide the radio into the radio housing
until it snaps into place. (Figure D)
5. Snap the trim plate onto the front of the
radio housing. (Figure D)
6. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Re-connect the negative
battery terminal and test the radio for
proper operation.
7. Reassemble dash in reverse order
of disassembly.
(Figure A) (Figure B)
(Figure C) (Figure D)
Right side clip