Metra Electronics MPS-GEN01 User manual

Metra. The World’s Best Kits.®MetraOnline.com © COPYRIGHT 2020 METRA ELECTRONICS CORPORATION REV. 2/12/20 INSTMPS-GEN01
INSTALLATION INSTRUCTIONS
MPS-GEN01
Attention! Let the vehicle sit with the key
out of the ignition for a few minutes before
removing the factory radio. When testing the
aftermarket equipment, ensure that all factory
equipment is connected before cycling the
key to ignition.
KIT FEATURES
• ISO DDIN radio provision
• Replaces upper pocket
• Textured to match factory finish
KIT COMPONENTS
• A) Radio housing • B) Radio brackets • C) Phillips screws (12)
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• 1/8” drill bit
TABLE OF CONTENTS
Dash Disassembly ..................................................2
Kit Preparation .......................................................2
Kit Assembly ..........................................................3
A B C
Polaris General 2016-Up
Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle
specific applications

MetraOnline.com
2
DASH DISASSEMBLY KIT PREPARATION
1. Remove the storage pocket from the
upper dashboard. (Figure A)
Continue to Kit Preparation
(Figure A) (Figure A)
1. Enlarge the storage pocket opening to
allow room for the aftermarket radio
and mounting kit. (Figure A)
Continue to Kit Assembly
Remove shaded area

REV. 2/12/2020 INSTMPS-GEN01 3
KIT ASSEMBLY
1. Secure the radio brackets to the radio
housing using (4) Phillips screws
provided. (Figure A)
2. Slide the radio into the radio housing
assembly, then secure using screws
supplied with the radio. (Figure B)
3. Complete all necessary connections to
the radio, then test the radio for proper
operation. Use Metra part number 44-
UA20 (sold separately) for an antenna.
4. Slide the radio assembly into the dash.
Pre-drill (8) pilot holes in the dash
using a 1/8” drill bit. Using a manual
screwdriver, secure the radio assembly
to the dash using (8) Phillips screws
provided. Do not overtighten! (Figure C)
(Figure A)
(Figure C)
(Figure B)

KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
®
Metra recommends MECP
certified technicians
Metra. The World’s Best Kits.®MetraOnline.com © COPYRIGHT 2020 METRA ELECTRONICS CORPORATION REV. 2/12/20 INSTMPS-GEN01
INSTALLATION INSTRUCTIONS
MPS-GEN01
If you are having difficulties with the installation
of this product, contact our Tech Support line
either by phone at 386-257-1186, or email at
[e-mail]. Before
doing so, look over the instruction booklet a
second time and ensure that the installation was
performed exactly as the instruction booklet
is stated. Have the vehicle apart and ready to
perform troubleshooting steps before contacting
Metra/Axxess Tech Support.