Metra Electronics 99-2006 User manual

INSTALLATION INSTRUCTIONS FOR PART 99-2006
1-800-221-0932 www.metraonline.com
©COPYRIGHT 2004-2008 METRA ELECTRONICS CORPORATION
KIT FEATURES
•Double DIN Radio Provision
•Stacked DIN Head Units Provision
•Painted To Match Factory Dash
99-2006 = BLACK
99-2006G = GRAY
•DIN Radio Provision with Pocket
•ISO Mount Radio Provision with Pocket
A) Radio Housing • B) DDIN Brackets • C) DDIN Trim Plate • D) ISO Brackets • E) Trim Plate • F) (8) Phillips screws
•(G) Pocket
KIT COMPONENTS
TOOLS REQUIRED:
99-2006/
99-2006G
A
APPLICATIONS
Cadillac CTS 2003-2007
Cadillac SRX 2004-2006
C
D
B
Phillips Screwdriver • Small Flat Blade Screwdriver • Socket Wrench
E
F
G

Dash Disassembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Kit Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2, 3, 4
Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
TABLE OF CONTENTS
99-2006
K NOWLEDGE IS P OWER
Enhanceyour installation and fabrication skillsby
enrolling in the most recognizedandrespected
mobile electronics school in our industry.
Log onto www.installerinstitute.comor call
800-354-6782 for more informationandtake steps
toward abetter tomorrow.

99-2006
1
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
Unclip and remove the center air
vent assembly above the radio.
(Figure A)
2
Open ashtray and remove (1) Phillips
head screw from inside ashtray.
3
CADILLAC CTS 2003-2007
CADILLAC SRX 2004-2006
Unclip and remove the a/c control/
ashtray assembly below the radio.
(Figure B)
4
Remove (4) 10 MM screws securing
the radio to the dash.
(Figure C, D)
5
DASH DISASSEMBLY
11:39 PM
60 60
A
11:39 PM
60 60
Rear View
B
11:39 PM
C
11:39 PM
D

99-2006
KIT ASSEMBLY
2
Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs down.
(Figure A)
1
Mount the ISO Brackets to the head
unit with the screws supplied with
the unit.
(Figure A)
1
A
A
B
Slide the aftermarket head unit into
the cage and secure. (
Figure B)
2
Slide the supplied pocket into the
unused opening.
3
Slide the supplied pocket into the
unused opening.
4
Slide the head unit into the radio
opening until the side clips engage.
(Figure B)
2
Snap the Trim plate into the Radio
Housing. (Figure B)
3
ISO MOUNT RADIO PROVISION WITH POCKET
B
DIN RADIO PROVISION WITH POCKET

3
99-2006
KIT ASSEMBLY
Remove the center bar from the 99-
2006 radio housing. (Figure A)
1
Attach the corresponding bracket to
the DDIN head unit.
(Figure B)
2
Insert the DDIN trim plate into the
radio housing. (Figure C)
3
Position the bracket/radio assembly
to the backof the radio housing and
secure with the (8) Phillips screws
provided.
(Figure D)
4
DOUBLE DIN RADIO PROVISION
A
B
C
Rear View
D

99-2006
KIT ASSEMBLY
4
Slide the DIN cages into the Radio
Housing and secure by bending the
metal locking tabs outward.
(Figure A)
1
A
B
Slide the aftermarket head units into
the cages and secure. (Figure B)
2
STACKED DIN HEAD UNITS PROVISION

5
FINAL ASSEMBLY
1
Locate the factory wiring harness in the dash and make the connection as shown.
Metra recomends using the proper mating adapter and making the connections as
shown. (Isolate and individually tape off the ends of any unused wires to prevent
electrical short circuit.)
2
Re-connect the negative battery terminal and test the unit for proper operation.
3
Reassemble radio and dash assemblies in reverse order of disassembly.
A
A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
B
C
D
Make wiring connections using the EIA color code chart shown below and the instructions included with the head
unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually
tape off ends of any unused wires to prevent electrical short circuit.
12V Ignition / Acc . . . Red
12V Batt / Memory . . Yellow
Ground . . . . . . . . . . . Black*
Power Antenna . . . . . Blue
Amp Turn-On . . . . . . Blue / White
Amp Ground . . . . . . . Black / White
Illumination. . . . . . . . Orange
Dimmer . . . . . . . . . . Orange / White
Right Front (+) . . . . . Gray
Right Front (-). . . . . . Gray / Black
Left Front (+) . . . . . . White
Left Front (-) . . . . . . . White / Black
Right Rear (+). . . . . . Violet
Right Rear (-) . . . . . . Violet / Black
Left Rear (+). . . . . . . Green
Left Rear (-) . . . . . . . Green / Black
*NOTE: When Black a wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’sspecifications.
METRA / EIA WIRING CODE
FINAL WIRING CONNECTIONS
99-2006
KIT ASSEMBLY

INST992006
1-800-221-0932 www.metraonline.com
Rev. 08-08-08 © COPYRIGHT 2004-2008 METRA ELECTRONICS CORPORATION INST99-2006