Metra Electronics 99-6504 User manual

APPLICATIONS
INSTALLATION INSTRUCTIONS FOR PART 99-6504
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness:
• 70-1817 - Chrysler harness 1984-2006 (vehicle specific)
• 70-6502 - Chrysler harness 2002-up (vehicle specific)
• 70-1818 - Chrysler amplifier integration harness 1984-up
(vehicle specific)
• 70-6503 - Chrysler/Dodge amplifier integration harness
2002-up (vehicle specific)
Antenna Adapter:
• 40-CR10 - Chrysler factory antenna to aftermarket radio
adapter cable 2002-up
• Phillips screwdriver • Torx #20 • Socket wrench • Small flat blade screwdriver
TOOLS REQUIRED
A
• A) Radio housing • B) ISO brackets
KIT FEATURES
KIT COMPONENTS
• ISO head unit provision with pocket
Chrysler multi-kit 1998-2009
99-6504
See application list inside
B

99-6504
Applications
Chrysler
300M 1999-2004
Concorde 1998-2004
LHS 1998-2001
PT Cruiser 2001-2005
Sebring 2001-2006
Town & Country 2001-2006
Dodge
Caravan 2001-2006
Dakota 2001-2004
Durango 2001-2003
Intrepid 1998-2004
Neon 2000-2006
Ram 2002-2005
Stratus 2001-2006
Viper 2003-2006
Jeep
Grand Cherokee 1999-2004
Liberty 2002-2006
Wrangler 2003-2006
Plymouth
Neon 2000-2001

Dash Disassembly 99-6504
Chrysler 300M/Concorde 1998-2004
LHS 1998-2001/Dodge Intrepid 1998-2004
1. Remove the ashtray by pressing down
on the inner spring clip. (Concorde only)
2. Unclip gear shifter trim panel
and slide trim panel toward the rear
of the vehicle.
3. Unclip dash trim panel and disconnect
the wire to the trim panel. (Figure A)
4. Remove (4) Phillips head screws
securing the radio. Disconnect and
remove the radio.
Continue to kit assembly (Figure A)

Chrysler PT Cruiser
2001-2005
1. Unclip power window control panel.
Disconnect and remove panel.
2. Pull off climate control knobs.
3. Unclip and remove the dash trim panel.
(Figure A)
4. Remove (4) Phillips head screws
securing the radio. Disconnect and
remove the radio.
Continue to kit assembly
(Figure A)
Dash Disassembly 99-6504

Dash Disassembly 99-6504
Chrysler Sebring/Dodge Stratus
2001-2006
1. Remove (2) Phillips head screws from
under the climate controls. (Coupe only)
2. Unclip and remove radio trim panel.
(Figure A)
3. Remove (4) Phillips head screws
securing the radio. Disconnect and
remove the radio.
Continue to kit assembly
(Figure A)

Chrysler Town & Country/Dodge Caravan
2001-2006
1. Open cup holder. Unclip and remove
trim above cup holder.
2. Remove (2) Phillips head screws from
above cup holder. (Figure A)
3. Unclip and remove the dash trim panel.
(Figure A)
4. Remove (4) Phillips head screws
securing the radio. Disconnect and
remove the radio.
Continue to kit assembly (Figure A)
Dash Disassembly 99-6504

Dash Disassembly 99-6504
Dodge Neon 2000-2006/Plymouth
Neon 200-2001
1. Pull off climate control knobs.
2. Unclip and remove A/C and heater
vents. (Figure A)
3. Remove (1) Phillips head screw from
each vent cavity.
4. Unclip and remove dash trim panel.
(Figure A)
5. Remove (4) Phillips head screws
securing the radio. Disconnect and
remove the radio.
Continue to kit assembly
(Figure A)

Dodge Ram
2002-2005
1. Unclip the top edge of the trim panel
below the steering column. Note, it is
not necessary to completely remove
this panel.
2. Remove (1) Phillips head screw from
below right A/C and heater vent.
3. Unclip and remove dash trim panel.
(Figure A)
4. Remove (4) Phillips head screws
securing the radio. Disconnect and
remove the radio.
Continue to kit assembly
(Figure A)
Dash Disassembly 99-6504

Dodge Viper 2003-2006
Dash Disassembly 99-6504
1. Using a small flat blade screw driver,
pry up on center console trim panel.
Note, be careful not to scratch the trim
panel. (Figure A)
2. Loosen the shifter lock nut below
center console trim panel (Figure A)
and unscrew the shifter knob.
(Figure B)
3. Unplug electrical connectors and
remove center console trim panel.
(Figure C)
4. Remove (6) Allen screws from
radio/climate control trim panel
and (1) Phillips screw at the bottom
of the panel.
5. Unplug electrical connectors and
remove the panel. (Figure D)
6. Remove (4) screws securing the radio.
Disconnect and remove the radio.
Continue to kit assembly
(Figure B)
(Figure D)
(Figure C)
(Figure A)

Jeep Grand Cherokee 1999-2004
1. Unclip and remove radio trim panel.
(Figure A)
2. Remove (4) Phillips head screws
securing the radio. Disconnect and
remove the radio.
Continue to kit assembly
(Figure A)
Dash Disassembly 99-6504