Mocka Dakota User manual

A CB
long bolt
x20
screw
x16
allen key
x1
WARNING: Any furniture that is not anchored to a wall has the potential to tip
over in certain circumstances, i.e. if a child attempts to climb up on the furniture
or in the event of an earthquake. Accordingly, we recommend that all furniture
is anchored to a wall. We supply a free safety wall anchor with all furniture sold
and we recommend these are used to prevent your product tipping. The fixing
device provided should fit most wall types, but please note that different wall
materials may require different fixing devices from those supplied.
Hardware Supplied
Phillips screwdriver required
Dakota Bookcase
1
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
E
bolt
x4
F
nut
x4
D
screw
x6
Wall Strap
x2
washer
Z
Y
wall
anchor
x1
X
safety
strap x1
WV
screw
x1
wall
screw
x1

Dakota Bookcase
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
2
12
Attach 8x panels [2] to 4x panels [1] and secure with 16x screws (B).
Tighten with a screwdriver.
Attach 2x panels [4] to panels [2], [3] and [1] and secure with
20x bolts (A). Tighten with an Allen key (C).
1
2
2
B
x 4
A
C
4
4
3
2
3
2
2
2
2
2
2
2
1
1
1
1

Dakota Bookcase
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
3
3 4
Attach panels [3] and [4] to panel [5] and secure with 6x screws
(D). Attach 1x safety strap (V) to the top of the back side of the
unit as shown using 1x washer (Z) and 1x screw (W).
Tighten with a screwdriver.
Attach 1x panel [6] to 2x panels [4] secure with 4x bolts (E) and
4x nuts (F). Tighten with a screwdriver.
4
4
6
E
F
4
4
3
D
5
3
V
Z
W
V
Z
W

Dakota Bookcase
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
4
65
Once assembled lift furniture into place, do not drag. Use a drill
to create a small hole lining up with the top of the safety strap (V).
Fasten to the wall using 1x washer (Z), 1x wall anchor (X) and 1x
wall screw (Y).
Ensure unit is balanced and steady before use. You’re done, enjoy!
X
Y
Z
X
Y
Z