Mocka Leon Barstool User manual

mocka.co.nz I mocka.com.au I
ASSEMBLY INSTRUCTIONS
Leon Barstool
Thank you for purchasing Leon Barstool. Please follow the
manufacturer’s assembly instructions in detail.
Read instructions carefully. Remove all wrapping material, staples and straps from the
carton. See hardware and furniture part list for guiddance. Be sure you have all parts
before you start assembling. Place all wooden furniture part a clean and flat soft
surface, such as carpet or rug to prevent from being scratched.
CAUTION :
KEEP ALL HARDWARE PART OUT OF REACH OF CHILDREN.
Phillips screwdriver required.
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
HARDWARE SUPPLIED
A
x4
50mm screw
B C D E
F
x2
dowel
G H
x29
screw
I
x1
allen key
x4
wood button
x2
30mm screw
x4
spring
washer
x4
screw pin
x2
40mm screw

mocka.co.nz I mocka.com.au I
ASSEMBLY INSTRUCTIONS
Leon Barstool
1 2
Attach 2 x legs (1) together as shown and secure with 1 x screw (F) and
2 x dowels (G). Tighten with a screwdriver.
Attach 1 x backrest (4) to asembled frame and secure with 2 x screws (C) and
2 x screws (B). Please make sure you use screw (C) for the top hole and screw
(B) for the bottom hole. Tighten with an Allen Key (H). Add 4 x wooden buttons
(I) as shown.
G
1
F
4
C
B
L
R
H
I

mocka.co.nz I mocka.com.au I
ASSEMBLY INSTRUCTIONS
Leon Barstool
3 4
Attach 2 x rails (2) to assembled frame as shown and secure with
4 x screws (F). Tighten with a screwdriver.
Attach 2 x support bars (3) to assembled frame as shown and secure with
4 x screw pins (E), 4 x spring washers (D) and 4 x screws (A). Tighten with an
Allen Key (H).
F
2
2
3
H
A
D
E

mocka.co.nz I mocka.com.au I
ASSEMBLY INSTRUCTIONS
Leon Barstool
5 6
Attach 4 x corner blocks (6) to assembled frame as shown and secure with
24 x screws (F). Tighten with a screwdriver.
Once assembled lift furniture into place, do not drag. Ensure unit is
balanced and steady before use. You’re done, enjoy!
66
F
F
E
F
F
F
F
Each side 4 x screws (F)