Mocka Vermont Cot User manual

Vermont Cot
1
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Thank you for your purchase.
Please follow the instructions below for correct assembly.
WARNING: TO PREVENT FALLS,THE MATTRESS BASE
OFTHIS COT SHOULD BE ADJUSTEDTOTHE LOWEST
POSITION BEFORETHE CHILD CAN SIT UP
Hardware Supplied
B C
A
x1
Allen key
x12
screw
x4
screw

12
Vermont Cot
2
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Attach 2 x panels [1] to panel [2] and secure with 4 x screws (A).
Tighten with an allen key (C).
Attach the cot mattress base at the required level using 4x screws (B)
as shown. Tighten all screws using the allen key (C).
A
AA
A
2
B
B
B
B
3
x4
A
C
x4
B
C
1
1

3
3
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Slide the remaining side panel into place and attach using 4x screws
(A) in the holes as shown. Tighten all screws using the allen key (C).
Turn the cot on the side and secure the base with 4x screws (B)
in the holes as shown. Tighten all screws using the allen key (C).
Vermont Cot
4
A
AA
A
2
x4
A
C
A
A
AA
B
C

5
4
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Vermont Cot
6
All done! Regularly check all screws are suitably tightened. Place the
correct size mattress into the cot before use. To clean use a damp
cloth, avoiding the use of detergents or abrasives. Once assembled lift
furniture into place, do not drag.
B
B
B
B
3
OPTIONAL/ MATTRESS HEIGHT ADJUSTMENT (please keep these
instructions handy for future reference)
To adjust mattress base settings, remove small plastic plugs. This will
require a small amount of force, please note these are not screws and
cannot be screwed out. You will need a screwdriver/ that fits into the
centre hole and possibly a hammer, or similar, to gently tap the end
until the plug pops out.
Repeat steps 2, 3 and 4 by removing the side panel and moving the
base to corresponding holes. Securely attach again in the adjusted
position.