Modena Giusto Series Owner's manual

Nomor: IMKG.547.02.2020
User
Manual Book
Portable Cooker
Giusto Series
PC 2721 L
PC 2721 LD
PC 2721

2
TABLE OFCONTENTS
Part 1: Safety Warnings 2
Part 2: Nameof Parts 3
Part 3: Installation 4
Part 4: How to Use 4
Knob Control 5
How to use the Burner 6
Part 5: Maintenance 7
Stainless Steel Part 7
Grid 7
Burner 7
Part 6: Trouble Shooting 7
Part 7: Precaution 8
Part 8: Specification 9
This guide book explains everything you need to know about your new product.
Please contact our Customer Care should you need further assistance through
www.modena.com

3
If you do not understand about the procedure installation of gas cooker, you should
contact MODENA Call Center to perform the installation.
Prepare the support equipment required for installation like:
LPG gas cylinder.
Gas hose with a safety standard for lack.
Clamp.
Gas regulator clamp / hose clamp with a lowpressure type.
Matches / gas lighter.
Room air ventilation
The air in the room that will be put gas appliances must have good ventilation so that
air can flow / move smoothly (there is circulation), if the air in the room can Not flow
then the air in the room will contain more combustion of the gas compared to oxygen.
It will cause the flame on the stove / burner is not perfect (a yellow flame because lack
of oxygen). Therefore, the room that will be put gas appliances should have good
ventilation.
PART 1: SAFETY WARNINGS

4
1. Pan support/Grid
2. Burner
3. Knob
4. Tempered glass
5. Feet
Image is a general overview and is not necessarily the same as the product you receive.
The features and product specifications depend on the product type
•Open the stove carton packaging, then take the stove out and put on a flat
surface.
•Stove must be placed at minimum distance of 15cm from side/back wall and
100cm from the ceiling.
PART 2: NAME OF PARTS
PART 3: INSTALLATION

5
•Insert the rubber hose at the end of the gas cylinder and regulator ot the
other end of the rubber. Try to get as deep as possible then tighten the
rubber hose with hose clamp.
•Open clamp on the gas cylinder. If there is a leak or strong gas smell, close
the gas tap immediately, then open the window so that gas comes out of
the kitchen room.
•The stove is ready to operate.
Knob Control
The amount of gas flow in the burner can be set on the knob as shown below:
OFF
No gas flow/OFF
Maximum gas flow and
Ignition
Minimum gas flow
1. To decrease/increase the fire on turned on burner:
Turn the knob to position the maximum fire sign or direction of the position of the
minimum fire sign.
2. To use the minimum fire:
Turn the knob to gas flow –Minimum .
ATTENTION
•To avoid gas leak, please use gas standardized hose with gas safety
device.
•Use the hose and regulator that are specified to avoid gas leak.
•Do not use a high pressure regulator.
PART 4: HOW TO USE

6
3. To turn off the fire on burner : Turn the knob to “OFF” symbols.
How to Use the Burner
To use the burner properly, compare the burner diameter with cooking equipment
diameter. Cooking equipment diameter must be proportional to the power of
burner so we can save the gas usage and fasten the cooking process.
Burner
Recommended Pot Diameter (cm)
Small
12–14
Medium
14-20
Large
18-26
Double Ring
18-28
Triple Ring
18-28
ATTENTION
In the event of a gas leak, do not turn on electronic equipment, turn on the
fan or testing by fire. Close the gas valve as soon as possible and open the
whole window/vent.
NOTE
•Cooking equipment with a wide bottom surface will quicken the cooking
process rather than those with smaller surface.
•Diameter of cooking equipment does not exceed the maximum
recommended size based on the above table.
•If the diameter exceeds the size of the cooking equipment that has been
recommended, then the hot stove/burner cannot circulate properly, this
can cause the glass top plate broken.
•Maximum load of cooking equipment and food ingredients are 10 kg.

7
MODENA gas cooker are designed specifically for long-term use so it does not
require complex treatment. However, there are some recommended steps to
lengthen the prime state.
Stainless Steel Part
Clean stainless steel part with a wet towel or special detergent for stainless
material. After that, dry it with soft towel.
Grid
Part of enameled grid can be wash or put into the dishwasher.
Burner
Burner can be removed and cleaned using soapy water. After cleaning, dry the
burner completely and reinstall it with the right position.
Problem
Possible Cause
Recommended Action
Smell of gas
•Gas leak
•Improper gas hose and
regulator installation
•Perform a gas leak test using soap
water to the gas hose, regulator,and
LPG cylinder, especially on
connection parts.
•Inspectgas hose and regulator, make
sure both are installed properly.
•If the smell of gas is still present,
detach the regulator from the LPG
cylinder and do not light any fire.
Contact MODENA Call Center
immediately.
PART 5: MAINTENANCE
PART 6: TROUBLESHOOTING

8
Problem
Possible Cause
Recommended Action
Abnormal fire
(red/small/unstable)
Gas supply is
obstructed/interfered.
•Make sure that the holes in the
burner is not clogged withspillovers.
•Clean the burner, including the fire
holes.
Insufficient gas amount
•Inspect the gas amount on the
regulator’s gas indicator. Make sure
the gas amount is still sufficient.
Lack of oxygen supply due
to improper air circulation.
•Make sure that the room’s air
circulation is convenient for gas use.
• Always lower the heat or turn off the fire before lifting pan from the burner.
•During cooking process, fat or oil must be carefully treated because this
material can get burnt if it reaches a certain temperature.
•When you smell gas, immediately release the regulator from the gas tank, do
not light a fire and immediately contact MODENA Call Center.
•Frequently check the gas hose, to make sure that gas hose is far from hot
surface, and not in bent position. Make sure the outer surface of hose isn’t
cracked so that can be a leakage.
•Always remember that territory around the gas stove can be hot for the long
time (around 30 minutes) after you turn off the gas stove.
•Do the routine service on your built-in oven every 3 (three) month, because if
the is something wrong on your Built-in oven, you can immediately detect and
repair
PART 7: PRECAUTION

9
TIPE
PC 2721 L / LD / LM
Numbers of Burner
2
Burners Composition
SS Burner + Brass Burner cap
Ignition Type
Piezoelectric
Heat Input
5.4 KW
Material
Stainless steel + Tempered glass
Color
Black
Gas Type
LPG
Grid type/Pan support
Enameled Pan Support
Product Dimension (L x W) mm
710 x 380
Specifications of this appliance may change without notice to improve the quality
of the product. Pictures in this manual are schematic and may not match your
product exactly. Values stated on the machine labels or in the documentation
accompanying it are obtained in laboratory in accordance with the relevant
standards. Depending on operational and environmental conditions of the
appliance, values may vary.
PART 8: SPECIFICATION

06/21
PT MODENA INDONESIA
Jl. Industri Raya I Blok D-8,
Jatiuwung, Tangerang 15135