Modena FF 1050 ETSS Owner's manual

User
Manual Book
Deep Fryer
Electric Deep Fryer
Gas Deep Fryer
FF 1050 ETSS
FF 2110 ETSS
FF 1050 GNSS
FF 2110 GNSS

TABLE OF CONTENT
Part 1: Safety Information 2
Environmental Notice 2
Part 2: Name of Parts 3
Part 3: Quick Start Guide 4
Part 4: Maintenance 4
Cleaning and Maintenance 4
Part 5: Troubleshooting 5
Part 6: Specification 6
This guide book explains everything you need to know about your new
product. Please contact our Customer Care should you need further
assistance through www.modena.com.

3
Read the user manual book carefully
•This appliance is for commercial use only.
•Improper installation, maintenance, cleaning, or modification to the
appliance could lead to severe injury or death and could damage the
appliance.
•Only use low pressure gas valve. DO NOT use middle or high
pressure gas valve
•DO NOT place the appliance near flammable materials such as
gasoline, fat, clothes, etc.
•When positioning the appliance, ensure the supply cord is not
trapped or damaged.
•Do not locate multiple portable socket-outlets or portable power
supplies at the rear of the appliance. Do not use plug adapter.
•If the supply cord is damaged, it must be replaced by the
manufacturer, an authorized service agent or similar qualified
persons, in order to avoid a hazard.
•DO NOT place the appliance in a wet or humid room or in an area
prone to water exposure such as near water leaks, rain, etc.
•Place the appliance in a well ventilated area.
•Beware of hot surface area as it may cause severe burning injury.
•DO NOT attemp to disassemble or repair the appliance. It should be
done by certified technician. Call MODENA Service Center.
Environmental Notice
The packaging material used is recyclable. We recommend
that you separate plastic, paper and cardboard and give
them to recycling agents. According to WEEE (Waste of
Electrical and Electronic Equipment) guidelines, waste from
electrical and electronic devices should be collected
separately. If you need to remove of this appliance in the
future, do not throw it away with the rest of your domestic garbage.
Instead, please take the appliance to the nearest WEEE collecting
agents, where available.
PART 1: SAFETY INFORMATION

4
*Above picture is for reference only. Difference between the picture and actual
product may occur
**Feature and equipments differ by each product
PART 2: NAME OF PARTS
Temperature knob
Indicator light
Basket
Oil pan
Cover
Flame control knob
Flame check window

5
Electric Deep Fryer
1. Before operation, check the power plug connection. Green light will
turn on when electricity is connected properly.
2. Pour sufficient cooking oil into the pan. Oil must cover at least half
of the oil pan.
3. Turn the knob clockwise to and select the desired temperature.
Yellow indicator light will turn on indicating the heater is working.
4. Wait until the oil reached desired temperature, yellow indicator light
will turn off when temperature is reached.
5. Insert foods into the frying basket, then insert the basket into the hot
oil.
6. After using, turn off the unit by rotating the knob to the initial zero
position.
7. To remove the oil, wait until the unit and the oil has cooled down.
Beware of hot surface! After that, disassemble the top panel to take
the bottom oil pan.
Gas Deep Fryer
1. Before operation, check the gas connection and make sure there is
no gas leakage.
2. Pour sufficient cooking oil into the pan. Oil must cover at least half
of the oil pan.
3. Turn the knob counter-clockwise to ignite the flame.
4. After the pilot flame is ignited, turn the knob counter-clockwise to
control the flame intensity.
5. After using, turn of the flame by turning the knob clockwise until its
initial position.
6. Insert foods into the frying basket, then insert the basket into the hot
oil.
7. After using, turn off the unit by rotating the knob to the initial zero
position.
8. To remove the oil, wait until the unit and the oil has cooled down.
Beware of hot surface!
PART 3: QUICK START GUIDE

6
Cleaning and Maintenance
To make sure that the appliance is in optimum condition, the appliance
must be cleaned regularly.
•Before performing cleaning activity, switch off the appliance and
disconnect the gas hose or the power plug.
•The appliance is made from Stainless Steel, however it is not
completely rust-proof. Do not use abrasive cleaners such as steel
wire brush, chlorine, acid-based cleaners. It may cause the
appliance to rust.
•Do not use high pressure washer.
•Clean the appliance using cloth, lukewarm water and mild soap. After
that, clean with clean water and dry completely.
•After everything is dried completely, install the accessories and
appliance to the initial position.
PART 4: MAINTENANCE
IMPORTANT!
•Appliance must not be connected to the gas hose to avoid any
gas leak.
•Appliance must not be connected to the power outlet to avoid
electric shock.

7
Check the following before contacting our Service Center in the event
of malfunction
Problem
Possible Cause
Recommended Action
(Electric) Unit
cannot turn on
•Blown fuse
•Change the fuse
(Electric) Green
and yellow
indicator is ON,
but oil
temperature does
not rise
•Electric heating tube
connection is loose
•Electric heating tube
burned
•Repair heating tube
connection
•Change heating tube
(Electric) Yellow
indicator is ON,
but the
temperature does
not rise
•Thermo-controller faulty
•Change thermo-controller
(Electric) Green
indicator is OFF
•Indicator faulty
•Replace indicator
(Gas) Ignition
problem
•Faulty pilot gas valve
•Call MODENA Service
center to check or replace
the pilot gas valve
(Gas) Smell of gas
•Improper gas hose
installation
•Check the gas hose
installation
•Perform gas leak test
•Repair the gas hose
connection
PART 5: TROUBLESHOOTING

8
MODEL
FF 1050 ETSS
FF 2110 ETSS
Type
Electric
Electric
Tank
Single
Double
Tank Capacity (L)
5.5
2×5.5
Thermostat
Yes
Yes
Temperature range (°C)
50-190
50-190
Oil Drainage
No
No
Rated Power (W)
2,500
5,000
Rated Voltage (V)
220
220
Rated Frequency (Hz)
50
50
Product dimension
(WxDxH)(mm)
285×460×300
560×460×310
MODEL
FF 1050 GNSS
FF 2110 GNSS
Type
Gas
Gas
Tank
Single
Double
Tank Capacity (L)
5.5
2×5.5
Burner Power (kW)
5.2
10.4
Oil Drainage
No
No
Ignition
Piezo
Piezo
Gas Input
LPG
LPG
Gas pressure (kPa)
2.8
2.8
Product dimension
(WxDxH)(mm)
290×520×470
550×520×470
Design and specification can change without prior notice to improve the quality of the
product. The illustration in this manual is schematic and can be different with your actual
product. The values on label or in other documents are according to laboratory test and
relevant standards. Values can vary depending on the actual operational and
environmental condition of the product.
PART 6: SPECIFICATION

05/23
PT MODENA INDONESIA
Jl. Industri Raya I Blok D-8,
Jatiuwung, Tangerang 15135