modway EEI-2937 User manual

︱ Page 1 of 3
EEI–2937 LOUNGER
Hardware:
Component:
A Bolt M8x50mm
x 4
Thank you for purchasing the MODWAY LOUNGER!
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the lounger, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
C
Allen Wrench M5 x 1
Customer Service 908-368-1025 www.modwayfurniture.com
1. Lounger Frame x1
2. Legs Wheels x1
3. Legs x1
4. Cushion x1
1
2
3
4
B Bolt M8x40mm
x 16

Customer Service 908-368-1025 www.modwayfurniture.com
STEP 1:
STEP 2:
Please assemble Legs Wheels (2) first and connect it with the Wooden support.
Next connect Legs (3) into the Wooden support. Insert Bolt (A) to tighten the Legs each side (Left and Right),
tighten using Allen Wrench (C).
Page 2 of 3
Carefully turn over the Lounger Frame (1) in a carpeted or padded area.
Secure the assembled Legs Wheels (2) and Legs (3) to the Lounger Frame (1) with 8 pieces of Bolts (A) each Legs, ghten it
with Allen wrench (C).
Hardware & Tool required
EEI–2937 LOUNGER
A
x2
7 cm
A
x2
7 cm
2
3
1
2
A
A
A
C
3
A
A
A
C
Hardware & Tool required
Cx1

Customer Service 908-368-1025 www.modwayfurniture.com
Assembly is complete. Your lounger is ready to be used now!
Page 3 of 3
EEI–2937 LOUNGER
STEP 3:
STEP 4:
Insert assembled Legs Wheels (2) and directly insert the Bolt (B), tighten with Allen Wrench (C).
Insert assembled Legs (3) and directly insert the Bolt (B), tighten with Allen Wrench (C).
Carefully position the assembled chair to the desired location.
Put Cushion (4) into the assembled lounger as shown.
Bx16 Cx1
Hardware & Tool required
1
3
2
B
C
B
B
B
B
B
B
B
4
1
3
2