modway EEI-3422-NAT-WHI User manual

EEI-3422-NAT-WHI OTTOMAN
Customer Service 908-368-1025︱www.modway.com Page 1 of 3
Hardware:
Component:
A Bolt M6x50mm
x 8
Thank you for purchasing the MODWAY OTTOMAN.
BAllen Wrench M5 x 1
1
2
3
5
1. Seat Frame
2. Left Frame
3. Right Frame
4. Support Wooden
5. Cushion x1
x2
x1
x1
x1
4
Before you start, here are some helpful advice:
We suggest you spend a short time reading through this leaflet and then follow the simple
step by step instructions.
Owing to the size and weight of the ottoman, we recommend that it is assembled by two adults,
on a carpeted or padded area, in the room that it is intended for. Approximate assembly
time: 30 minutes.
Please do not use any tools other than those provided or recommended in these instructions.
Please do not throw away any of the packaging or instructions until you have checked all
the components and hardware and the furniture is fully assembled.
Assemble all components loosely until advised to tighten. Depending on use, it may be necessary
to tighten the components from time to time, so please save the tools that have been provided.
Please keep all pieces out of reach of small children.
1.
2.
3.
4.
5.
6.

EEI-3422-NAT-WHI OTTOMAN
Customer Service 908-368-1025︱www.modway.com Page 2 of 3
STEP 1:
STEP 2:
Please put Left Frame (2) on a carpeted or padded area.
Insert the tenon on Seat Frame (1) into the rabbet on Left Frame (2) at first.
Insert wooden bar or Support Wooden (4) one by one through drilling hole.
Carefully position Right Frame (3) to the assembled Seat Frame (1), Left Frame (2) and Support Wooden (4) as
shown.
Insert the tenon on Seat Frame (1), Left Frame (2) and Support Wooden (4) into the rabbet on Right Frame (3).
Ax8 Bx1
Carefully turn over the assembled Seat Frame (1), Left Frame (2), Right Frame (3) and Support Wooden (4).
Insert 4 pieces of Bolt (A) into the pre-drilled holes on Seat Frame (1) through the top pre-drilled holes on Left
Frame (2).
Use Allen Wrench (B) to tighten Bolts (A) clockwise until secure.
Repeat the same steps for Right Frame (3).
Hardware & Tool required
2
1
4
4
2
4
1
4
3
1
2
3
4
A
B

STEP 3:
Assembly is complete. Your ottoman is ready to be used now!
Put Cushion (4) into the assembled ottoman as shown.
Carefully position the assembled ottoman to the desired location.
5
Customer Service 908-368-1025︱www.modway.com Page 3 of 3
EEI-3422-NAT-WHI OTTOMAN