modway EEI–2460 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI–2460 BENCH
Hardware:
Component:
ABolt M8x65mm x 12
B
1
Bench Body x1 3 Right Leg x2
Thank you for purchasing the MODWAY BENCH!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the bench, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
1
E
2
Spring Washer M8 x 12
Allen Wrench x 1
CFlat Washer M8 x 12
3
2
2 Left Leg x2
3
DPlastic Washer x 12

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI–2460 BENCH
STEP 1:
STEP 2:
Hardware & Tool required
Ax12 Bx12 Cx12 Dx12 Ex1
1
3
C
2
B E
Please put the Bench Body (1) upside down on a carpeted or padded area by two adults.
Open the Velcro on the bottom of Bench Body (1) as shown, to make the corners fully visible.
Take out 4 pieces of Legs (2&3) and Hardware Package from the inside of Bench Body(1).
1 4pcs Bench Leg
Velcro on the bottom of bench body
+
Hardware Package
Position one of Left Legs (2) at the corresponding wooden corner as shown.
Insert 3 pieces of Bolt (A)with 3 pieces of Spring Washer (B), Flat Washer (C) into the pre-drilled holes on the apron of
Bench Body (1) through the pre-drill holes on Left Leg (2) , 3 pieces of Plastic Washer (D) as shown.
Repeat the same steps for the remaining Left Leg (2) and Right Legs (3).
Use Allen Wrench (E) to tighten all the Bolts (A) clockwise until secure.
Close the Velcro on bottom of Bench Body (1).
A B C
B
A
A
C
2
3
A B
C
A B C
A
B
C
D D
A
B
C
C
B
A
D
D
D
D

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI–2460 BENCH
Assembly is completed. Your bench is ready to be enjoyed now!
Carefully turn over the assembled bench.
STEP 3: