modway EEI-3711-NAT-TAU User manual

A
C
x 2
x 4
x 2
x1
x2
Hardware:
Component:
Page 1 of 4
Thank you for purchasing the MODWAY BENCH!
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the bench, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 15 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Customer Service 609-256-9000 www.modway.com
1. Back
2. Seat
3. Leg Frame
x1
1
2
3
3
4. Seat Cushion x1
B
Screw M6x50mm
Bolt M6x90mm
Nut M6
Allen Wrench M4
x 4
D
EEI-3711-NAT-TAU BENCH
4

Page 2 of 4
STEP 1:
Attach Leg Frame (3) to Seat (2) as shown.
Insert Nuts (C) to Seat (2) .Then insert 2 pieces of Bolts (B) through Legs Frame (3) into Seat (2).
Tighten with 2 pieces of Allen Wrench (D).
Hardware & Tool required
Hardware & Tool required
Customer Service 609-256-9000 www.modway.com
2
3
D
D
A
D
B
EEI-3711-NAT-TAU BENCH
C
STEP 2:
Attach Back (1) to Leg Frame (3) as shown.
Then insert 1 pieces of Screw (A) through Back (1) into Legs Frame (3).
Tighten with Allen Wrench (D).
x2
B
x2
D
x2
C
x1
C
x1
D

x2
B
3
x2
D
D
D
C
D
x2
C
B
EEI-3711-NAT-TAU BENCH
C
x1
C
x1
D
Page 3 of 4
Hardware & Tool required
STEP 4:
Hardware & Tool required
Customer Service 609-256-9000 www.modway.com
STEP 3:
Attach Leg Frame (3) to the assmebled Back (1) and Seat (2) as shown.
Insert Nuts (C) to Seat (2) . Then insert 2 pieces of Bolts (B) through Leg Frame (3) into Seat (2).
Tighten with Allen Wrench (D).
Insert 1 pieces of Screw (A) through Legs Frame (3) into Back (1).
Tighten with Allen Wrench (D).

Page 4 of 4
STEP 5:
Assembly is complete. Your bench is ready to be used now!
Customer Service 609-256-9000 www.modway.com
4
EEI-3711-NAT-TAU BENCH
Carefully position the assembled bench to the desired location.
Put the Seat Cushion (4) into the assembled bench as shown.