Morris MFS-16243 User manual

STAND FAN
INSTRUCTIONSMANUAL
Models: MFS-16243 / MFS-16244
Please read these instructions carefully and store them future reference

9. Care required with the use of this appliance in tropical climates.
Do not use it to temperatures over 40 °C.
SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always
be followed to reduce the risk of fire, electric shock and injury to
persons, including the followings:
1. To prevent fire or shock hazard, DO NOT expose this
appliance to rain or moisture.
2. Dangerous high voltages are present inside this enclosure. To
avoid electric shock, DO NOT open the cabinet, refer servicing to
qualified personnel only.
3. This appliance is intended for household use only and not for
commercial, industrial or outdoor use. Other - not
recommended - use may cause fire, electric shock or injury.
4. Ensure the fan is not placed near drapes,curtains, or any
objects that may be drawn into the fan.
5. To protect against fire, electrical shock and injury to persons, do
not immerse the unit, plug or cord in water or spray it with liquids.
6. The appliance shall not be exposed to dripping or splashing and
no objects filled with liquids, such as vases, shall be placed on
the product.
7. No naked flames sources, such as candles, should be placed on
the product.
8. Ventilation should not be impeded by covering the ventilation
openings. Slots and opening are provided for ventilation to
ensure reliable operation of the product and to protect it from
overheating.
10. Place the fan on a stable level and dry surface when
operating to avoid overturning.
11. Only connect to a suitably AC 220-240V~50Hz mains socket.
-2-

12. Do not operate the fan in the presence of explosive and / or
flammable fumes. Do not place the fan or any parts near an
open flame, cooking or other heating appliance.
13. Do not operate the fan with a damaged cord or plug, after a
malfunction or if it is dropped or damaged in any manner.
14. Do not operate the fan without the fan grilles properly in place.
15. Do not place the fan close to an open window. Rain
splashing on the fan could cause an electric shock hazard.
16. Do not let the power cord hang over the edge of a table or
counter or let it touch any hot surfaces.
17. Do not insert or allow foreign objects to enter the grille
openings as this may cause damage to the appliance.
2
18. Do not use the fan if grille becomes damaged or loose.
19. This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall
not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
20.
Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved. Children
aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
18. Do not use the fan if grille becomes damaged or loose.
19. This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
20. Children of less than 3 years should be kept away unless
continuously supervised. Children aged from 3 years and less
than 8 years shall only switch on/off the appliance provided that
it has been placed or installed in its intended normal operating
position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand
the hazards involved. Children aged from 3 years and less than
8 years shall not plug in, regulate and clean the appliance or
perform user maintenance.
-3-

22. To disconnect, grip the plug and pull it from the wall outlet.
Never pull by the cord.
23.Do not attempt to repair, disassemble or modify the
appliance. There are no user-serviceable parts inside.
Refer all servicing to qualified service personnel.
FOR HOUSEHOLD USE ONLY
21. Switch the fan OFF and unplug it from the outlet when it is
not in use, when moving fan from one location to another and
before cleaning.
SPECIFICATIONS:
Product: Stand Fan
Model: MFS-16243 / MFS-16244
Power: DC 40W
Voltage: 220V-240V / 50Hz
*The pedestal fan may only be used, if it is fully assembled.
Check all screw / plug connections at regular intervals.
Re-tighten loose screws and ensure that plug connections are
properly adjusted.
-4-
OVERVIEW OF APPLIANCE
1. Front Board
2. Front Grill
3. Small Blade
4. Big blade
5. Rear Grill Lock Nut
6. Grill Ring
7. Rear Grill
8. Motor
9. Motor Holder
10.Main Body / Mosquito killer tablet slot
11.Speed Knob
12.Control Panel
13. Main Body Fixed Screw
14. Holder Pipe
15. Holder Fixed Screw
16. Pipe Holder
17. Base
18. Base Fixed Screw
19. Remote Control

ASSEMBLY INSTRUCTIONS
1. Remove all the parts from the packing box.
2.Attach the telescopic tube (collumn) to the base. Secure by tightening the nut on the base.
Use the screw/nut provided to assemble the column parts to the base. Adjust the column to
the height and screw / secure with the fixed base screw (fig. 1,2).
-5-
3.
fig. 1 fig. 2
fig. 3
Insert the main body into the upper part of
the telescopic tube.
Tight by main body fixed screw on the back,
as shown at fig. 3.
fig. 4
4. Place the rear grill in front of the motor
and secure with its nut (fig. 4).

ATTENTION!
Before using the fan make sure that it is on a flat and stable surface. Damage may occur if it
is placed on inclined surface.
Then insert the plug on the socket.
The unit will emit a short "BEEP" sound indicating that power is supplied.
For your convenience,the unit can be operated by using control panel in the main body or
by using the - included in the package - remote control.
6. Connecting the front with the rear
grilles:
* Snap the front board onto the front
grille
* Install the grille ring to join the
2 grilles
* Align and fix by the small screw on
top, as shown at fig. 6.
fig. 6
5. Apply the big blade to the motor
shaft.
Then install the small blade and
secure by tightening
counterclockwise, as shown at fig.
5.
fig. 5
ASSEMBLY INSTRUCTIONS
-6-
Front Board

Control panel Remote Control
Remote control is supplied with battery inside.
Remove the transparent sheet from the battery cover before the use of the remote control.
If the battery has run out, it must be replaced with the same type,following the drawing on the
back of the remote control.
-7-

ON/OFF Button:
• Press the button to select the power on or power off.
•The indicator light will light up when power is on and light off when power is off.
TIMER Button:
•While the unit is operating, you can set the timer to switch the fan off automatically.
•Timer can be set from 1 hour - 12 hours;indicator will light up in the control panel.
•The unit will be powered off automatically after the setting time is reached.
MOSQUITO Button:
•Put the mosquito tablet into the tablet slot on the back side of the fan.
•Press the button;indicator will light up on the control panel.
•Press again, the indicator light will turn off and function will stop.
OSCILLATION Button:
•Press the oscillation button to activate the automatic oscillation from right to left. The related
indicator light will light up in the control panel.
•Press again the oscillation button to deactivate the automatic oscillation; the indicator light will turn
•While the unit is operating, you can select the working mode.
Note: The fan speed is setting by fixed program when the unit is selected in 'Sleep'or 'Nature'.
•For mode indicator lights (according to each mode), please refer to the sketches above.
•If mode indicator light is off, the fan working mode will turn into 'Normal'.
off at the control panel.
MODE Button
•There are 28 available speeds. The indicator light shows sequentially from 1 to 28 depending on
the desired setting.
Note: 1-9 = low speed, 10-18 = medium speed, 19-28 = high speed.
•Only while the unit is operating in 'Normal'mode, the fan speed can be selected by turning the
knob.
SPEED Knob:
Remark: When the device is operating in 'Sleep' or 'Nature' mode, no speed selection can be
made. So if while operating in 'Sleep' or 'Nature' mode the user tries to change the speed,
then the current mode ('Sleep' or 'Nature') will be disabled and unit will automatically switch to
'Normal' mode.
-8-
NOTE: During this function, the unit retains the speed at the higher level (28).

NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality
materials and components which can be recycled and reused.
This symbol means that electrical and electronic equipment,
at their end-of-life, should be disposed of separately from your
household waste.
Please dispose of this equipment at your local community waste collection /
recycling centre.
In the European Union there are separate collection systems for used electrical
and electronic products.
Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
Herewith, Kalliopi Karyda & Co Lp states that this product, complies with the
requirements of below directives:
EMC-Directive: 14 / 30 / EU
Low Voltage Directive: 14 / 35 / EU
ErP Directive 09 / 125 / EC
CE Marking: 93 / 68 / EEC
RoHS Directive: 11 / 65 / EU & 15 / 863 / EU
The detailed declaration of conformity can be found at www.morris.gr
Exclusive importer in Greece:
Kalliopi Karyda & Co., LP
87A, 17th Noemvriou str, P.C. 55534
Pylea Thessaloniki – Greece
T: [phone] | F: [phone]
www.morris.gr
CLEANING AND MAINTENANCE
NOTE: Before cleaning the appliance always disconnect the power plug from the receptacle.
1. DO NOT dip the device in water, or splash it with any other liquids.
2. DO NOT use solvents or any other chemical products for cleaning it. When you do not use it,
after cleaning it, store the fan in a dry place.
3. At the end of the season - when you stop using the fan - wipe off any dust to keep it in good
condition for the next season. If possible, disassemble the grille and remove the blades, and
then clean them with a soft damp cloth.