Moxa Technologies ioMirror E3200 Series User manual

P/N: 1802032100010
*1802032100010*
ioMirror E3200 Series
Quick Installation Guide
Ethernet Peer-to-Peer I/O
Version 1.0, January 2019
Technical Support Contact Information
www.moxa.com/support
Moxa Americas:
Toll
-free: 1-888-669-2872
Tel:
1-714-528-6777
Fax:
1-714-528-6778
Moxa China (Shanghai office):
Toll
-free: 800-820-5036
Tel:
[phone]
Fax:
[phone]
Moxa Europe:
Tel:
[phone]
Fax:
[phone]
Moxa Asia-Pacific:
Tel:
[phone]
Fax:
[phone]
Moxa India:
Tel:
[phone]
Fax:
[phone]

2019 Moxa Inc. All rights reserved.

- 2 -
Package Checklist
•1 x ioMirror E3200 Series peer-to-peer I/O product
•1 x quick installation guide (printed)
•1 x LDP1602 LCD module (optional)
Specifications
Power Parameters
Input Voltage
12 to 48 VDC
Power Consumption
136 mA @ 24 VDC
Environmental Limits
Operating Temperature
-10 to 60°C (14 to 140°F)
Storage Temperature
(package included)
-40 to 85°C (-40 to 185°F)
LED Indicators
Ethernet LEDs
Ethernet
Orange
Live 10 Mbps Ethernet connection
Green
Live 100 Mbps Ethernet connection
Blinking
Transmitting or receiving data
System LEDs
PWR
Red
Power is on
Off
Power is off
Ready
Red
System error
Green
ioMirror is functioning normally
Off
Power error condition exists
I/O LEDs
DI (1 to 8)
DO (1 to 8)
Green
Status is “on”
Off
Status is “off”
Alarm
Red
DI has lost connection with remote output module
Blinking
DO has lost connection with remote input module
DO PWR
Red
DO power in
I/O Wiring Diagrams
DI Dry Contact

- 3 -
DI Wet Contact
DO
Alarm Output
Mounting
There are two ways to mount the ioMirror E3200 Series: DIN-rail or wall
mounting.
•Mounting on a DIN rail
Pull out the bottom slider; latch the unit onto the DIN rail, and then
push the slider back in.
•Mounting on a wall
Pull out both the top and bottom sliders and align the
screws accordingly. The heads of the screws should
be less than 6.0 mm in diameter, and the shafts
should be less than 3.5 mm in diameter, as shown in
the figure.
Connecting to the ioMirror E3200
You have two ways to connect to the ioMirror E3200: by ioMirrorAdmin or
by web console.
•Default IP Address: 192.168.127.254
•Subnet Mask: 255.255.255.0

- 4 -
NOTE
Be sure to configure the host PC’s IP address to the same subnet
as the ioMirror E3200. For example: 192.168.127.253.
Restore Factory Defaults
There are three ways to restore the ioLogik to factory default settings.
1. Hold the RESET button for 5 seconds.
2. Right-click on the specific ioMirror in the ioMirrorAdmin utility and
select Reset to Default.
3. Select Load Factory Default from the web console.
NOTE
Refer to the user's manual for detailed configuration and settings
information.