Myson DÉCOR KH11 User manual

MYSON
DÉCOR KH11 & KH22
Mounting and Fixing instructions.
DÉCOR radiators are high performance,
universal radiators that come with a choice of
connection options;
lTop bottom same end (TBSE)
lTop bottom opposite end (TBOE)
lBottom bottom opposite end (BBOE).
These instructions show you how to correctly
install the radiator based on your connection
requirements.
IMPORTANT: Screws must be fastened and tightened
as shown in this document. Failure to correctly fasten
the screw will result in the product not functioning
correctly and may cause the product to leak.
Contents*
A
B
G
C
D
E
F
Model No. of screws required
Horizontal KH11 2 (1 on each side)
Horizontal KH22 4 (2 on each side)
Your DÉCOR radiator comes with a pack of brackets and screws
that contains the following:
Brackets for horizontal models x 4
(or 6 for larger radiators)
Short plug screws*
Long separating screw (red end)*
Decorative screw covers*
Anti vibe clip (horizontal and vertical only)
Plug and vent
Allen key
Please unpack and carefully check the contents, in the event that
items are missing please contact MYSON immediately and do
not commence the installation.
*quantities vary depending on the model. For full details see table below.
Table of model variations
G
B
C
D
E
F
A
Bracket packet kit for horizontal models.

Installation
For the correct water flow, the screws must be fitted, and secured, as
demonstrated in the diagrams below. The longer, separating screws
(with a red end) will direct the water flow through the radiator, while
the smaller metal screw plugs will blank off the unused tappings
(see Fig 1).
Once the screws are fitted, cover with the decorative screw caps
supplied (see Fig 2). The radiator is now ready to be mounted to the wall
or floor. Fit the anti vibe clip to the bracket as shown in Fig 3, and then
affix the radiator to the wall using the brackets supplied (measurements
can be found in the Universal Instructions found in the packaging).
MYSON Eastern Avenue, Team Valley, Gateshead, Tyne & Wear NE11 0PG, UK
T: 0845 402 3434, F: 0191 491 7568, [email protected], www.myson.co.uk
MYSON
V
LSS LSSSPS
SPS SPS SPS SPS
SPS SPS SPS SPS
SPS
P
V
P
P
V
P
V
PV P V
TBSE
V
LSS LSSSPS
SPS SPS SPS SPS
SPS SPS SPS SPS
SPS
P
V
P
P
V
P
V
PV P V
TBOE
V
LSS LSSSPS
SPS SPS SPS SPS
SPS SPS SPS SPS
SPS
P
V
P
P
V
P
V
PV P V
BBOE
DÉCOR Horizontal Flow and Return
KEY
Flow water inlet
Flow water outlet
VVent
PPlug
LSS Long Separation Screw (red end)
SPS Short Plug Screw
www.myson.co.uk
Fig 1. Fig 3. Horizontal & vertical models onlyFig 2.
COMPLETE HEATING SOLUTIONS