Myson Finesse EC Quick guide

PLEASE LEAVE THIS MANUAL WITH THE END USER
Class 1 - 230V - 50 Hz
FINESSE EC
INSTALLATION, OPERATING,
& INSTRUCTION MANUAL
FINESSE EC
INSTALLATION, OPERATING,
& INSTRUCTION MANUAL
COMPLETE HEATING SOLUTIONS
01.04.2016
MYSON Eastern Avenue, Team Valley, Gateshead, Tyne & Wear NE11 0PG, UK
T: 0845 402 3434, F: 0191 491 7568, [email protected], www.myson.co.uk
31018 Finesse Instalation Manual A5V2.qxp 13/03/2017 14:39 Page 1

Contents
1.0 Warnings & Safety Information 03
2.0 General Information 05
3.0 Maintenance, Repair & Disposal 05
4.0 Waste Disposal According to The WEEE Directive (2002/96/EC) 05
5.0 Installation 06
6.0 Operating Instructions 07
7.0 Technical Characteristics 07
8.0 Warranty 07
1.0 Warnings & Safety Information
SAFETY INFORMATION
This appliance can be
used by children aged
from 8 years and above
and persons with reduced
physical, sensory or
mental capabilities or
lack of experience and
knowledge, if they have
been given supervision
or instruction concerning
use of the appliance in a
safe way and understand
the hazards involved.
Children shall not play with
the appliance. Cleaning
and user maintenance
shall not be made by
children unless they
are older than 8 and
supervised.
Keep the appliance and
its cord out of reach of
children aged less than
8 years.
Children of less than
3 years should be kept
away from the unit unless
continuously supervised.
Children aged from
3 years and less than
8 years shall only switch
on/off the appliance
provided that it has been
placed or installed in
its normal operating
position and they have
been given supervision
or instruction concerning
use of the appliance in a
safe way and understand
the hazards involved.
Children aged from
3 years and less than
8 years shall not plug in,
regulate, clean the
appliance or perform
user maintenance.
03FINESSE ECFINESSE EC02
31018 Finesse Instalation Manual A5V2.qxp 13/03/2017 14:39 Page 3

2.0 General Information
lThis appliance is a sealed electric radiator
designed for fixed wall-mounted installation.
lThis appliance conforms to the standards
EN 60335-1 and EN 60335-2-30.
lThis appliance is class 1 and splash resistant
(IP44).
lThis appliance complies with the European
Directive 2004/108/EC (CE Marking on all
appliances).
lThis unit is supplied complete with a
connection cable and wall brackets.
Cable Hook Assembly
1. Power On/Off Switch
2. Power Cable
1.0 Warnings & Safety Information (cont...)
CAUTION
Some parts of this
product can become very
hot and cause burns.
Particular attention has to
be given where children
and vulnerable people
are present.
In order to avoid
overheating, do
not cover the radiator.
“Do not cover” means
that the radiator must
not be used for drying
clothes, for example,
by placing them directly
on the radiator.
IMPORTANT SAFETY
INSTRUCTIONS!
Before starting work disconnect power supply!
All installation work and wiring work related to the
radiators, thermostats and programmers must be
carried out only when de-energized.
The appliance should be installed by and
commissioned by qualified professionals only.
Make sure to adhere to valid safety regulations.
Any repairs or maintenance within the warranty
period should be carried out only by approved
service engineers confirmed by MYSON.
For the correct installation of radiators it is
essential that the fixing of the radiator is carried
out in such a way that it is suitable for intended
use AND predictable misuse. A number of
elements need to be taken into consideration
including the fixing method used to secure the
radiator to the wall, the type and condition of the
wall itself, and any additional potential forces or
weights, prior to finalising installation. IN ALL
CASES IT IS STRONGLY RECOMMENDED THAT
A SUITABLY QUALIFIED PROFESSIONAL
INSTALLER OR SIMILAR TRADESPERSON
CARRIES OUT THE INSTALLATION.
PLEASE NOTE: The fixing materials provided are only
intended for installation on walls made of solid wood,
bricks, concrete or on timber-frame stud walls where the
fixing is into the timber. All walls being considered should
have no more than a maximum of 3mm wall finishing. For
walls made of other materials, for example hollow bricks,
please consult your installer and/or specialist supplier.
ONCE AGAIN, IF YOU ARE UNSURE, IT IS
STRONGLY RECOMMENDED THAT A SUITABLY
QUALIFIED PROFESSIONAL INSTALLER OR SIMILAR
TRADESPERSON CARRIES OUT THE INSTALLATION.
The radiator is equipped with an overheat
protection that cannot be reset (melt fuse). This
overheat protection disconnects the current if the
radiator becomes too hot (e.g. when covered).
If the supply cord is damaged, it must be replaced
by the manufacturer, his service agent or similar
qualified persons in order to avoid a hazard.
The radiator is filled with an exact amount of
environmental friendly vegetable oil. Any repairs
that require the radiator to be opened shall
therefore only be carried out by the manufacturer
or his approved agent. Please contact MYSON in
case of leakage.
05FINESSE ECFINESSE EC04
3.0 Maintenance, Repair & Disposal
lUse only a damp cloth for cleaning and
wiping of the radiator which should be
switched off at this time.
lWhen scrapping the radiator, follow the
regulations concerning the disposal of oil.
4.0 Waste Disposal According to The WEEE Directive (2012/19/EU)
Waste disposal according to the
WEEE Directive (2012/19/EU).
The symbol on the product label
indicates that the product may
not be handled as domestic
waste, but must be sorted separately. When it
reaches the end of its useful life, it shall be
returned to a collection facility for electrical
and electronic products. By returning the
product, you will help to prevent possible
negative effects on the environment and health
to which the product can contribute if it is
disposed of as ordinary domestic waste. For
information about recycling and collection
facilities, you should contact your local
authority/municipality or refuse collection
service or the business from which you
purchased the product. Applicable to countries
where this Directive has been adopted.
WARNING
This radiator is not equipped
with a device to control the
room temperature. Do not use
this radiator in small rooms when
they are occupied by persons
not capable of leaving the room
on their own, unless constant
supervision is provided.
31018 Finesse Instalation Manual A5V2.qxp 13/03/2017 14:39 Page 5

07FINESSE ECFINESSE EC06
5.0 Installation 5.0 Installation (cont...)
lThis product is splash resistant with an IP44
rating. This must be considered when
installing in a location containing a bath or
shower, as defined by BS 7671.
lThe radiator may be positioned in zone 2
(figure 4) of the bathroom, in so far as no
operating controls (button, switch, etc.) are
in reach of persons in the bath or under
the shower.
FIXING
lMark out the distance between the brackets
and the positions for the screw holes as
shown in figure 2 and the dimension tables
at the top of page 7, and ensure the safety
clips are used (see figure 3).
A B
C
D
H
L
FLOOR
CONNECTION
lThe electrical installation must comply with
local or national regulations.
lThe radiator must be connected to the
electrical supply, using a switched fused
spur with 3mm separation on all poles.
lIf the radiator is installed in a bathroom or
shower room, it must be protected with a
residual current device (RCD) with a rated
residual current not exceeding 30 mA.
lThe radiator should be connected by a
suitable and qualified electrician.
C135 205
D90 163
Height
(mm) 300 500
A160 160 160 160 160 160 160 160 160 160
B101 203 355 508 660 711 965 1016 1320 1727
400 500 650 800 950 1000 1250 1300 1600 2000
FINESSE EC Double Panel (refer to figure 2)
Figure 2. Figure 3.
Figure 1.
Min.100mm
Min.100mm
Min.100mm
Step 1 Step 2
POSITIONING
lThe radiator must be positioned horizontally,
the right way up on the wall in order for it to
function correctly. Never switch the radiator
on in any other position as this will damage
the electrical element.
lThe radiator must be positioned according
to the applicable standards and the
minimum distances as specified in figure 1
should be carefully observed.
lThe radiator must not be located
underneath an electric socket.
Zone 1 Zone 2
Zone 2
Zone 0
OUTSIDE ZONES
3m 2.25m
0.6m
0.6m
Figure 4.
Safety Clip-on Brackets
6.0 Operating Instructions
The On/Off button (see page 5) is located at
the bottom of the control side of the radiator.
The radiator should only be switched “on”
when it is correctly installed and secured to
the wall brackets.
7.0 Technical Characteristics
-10°C + 50°C
Class 1 – IP44
230 VAC – 50 Hz
lEN 60335-1
lEN 60335-2-30
lEN 60529
lLV Directive 2006/95/EC
lRoHS Directive 2002/95/EC
Operating temperature
Electrical protection
Power supply
The radiator has been designed to
comply with the following Directives
and Standards.
8.0 Warranty
The product is covered by a 10 year warranty
except for the electrical and electronic
components that are covered by a 2 year
warranty.
Length
(mm)
31018 Finesse Instalation Manual A5V2.qxp 13/03/2017 14:39 Page 7