Myson Finesse User manual

- 1 -

FINESSE

Oil-lled electric radiator with electronic thermostat

MANUAL

InstallatIon and operatIng InstructIons

- 2 -

- 3 -

8-9 mm

2 3

300

500

125

325mm

147 mm

- 2 -

- 3 -

Congratulations on the purchase

of your new Myson Finesse!

Myson Finesse Electric panel for wall mounting tted with electronic

thermostat. Supplied with connecting cable, wall brackets

and screws.

Rated voltage 240V.

IP 44.

InstallatIon

MountIng

Fig. 1.

The supplied wall brackets are mounted on wall with enclosed screws. The

brackets should be placed approx. 100–150 mm in from each end of the radiator.

The brackets can be used to mark out the height.

Fig. 2, 3.

Note! The specied minimum measurements to oor, window sill and side wall

must be observed. The measurement in g. 3 between oor and lower xing hole

gives a distance of 100 mm between the oor and lower edge of the radiator. For

the radiator to function correctly it must be mounted level.

Fig. 4.

The top of the wall brackets can be pulled up and locked in their top position to

simplify the mounting of the radiator. Make sure when locking the radiator in the

brackets that the upper part of the brackets properly grip the edge of the radiator.

The radiator is reversible. The thermostat housing should always be at the

bottom, closest to the oor. The radiator must not be placed immediately under

a wall socket.

ElEctrIcal

Connect the radiators 3-core cable to a suitable terminal box as follows:

Brown wire Live

Blue wire Neutral

Green/yellow wire Earth

This appliance must be connected to the fixed wiring of the premises through a

cable outlet (5 Amp max).

For installation in a bathroom (to comply with current I.E.E regulations) the

appliance must be wired in the manner prescribed via a double-pole switch

having a contact separation of at least 3mm in all poles, mounted outside the

bathroom. This radiator should be mounted in zone 3 of the bathroom (fig. 5).

WarnIng

THIS APPLIANCE MUST BE EARTHED through the medium of the 3 core

connection cable.

This radiator should be fitted by a competent electrician.

HoW to usE

Fig. 6.

The radiator is switched on by setting the switch to position I, see g. 6a. The

required room temperature is set with the thermostat dial, see g. 6b. The green

indicator lamp is on when the radiator is emitting heat, see g. 6c.

Fig. 7.

The radiator is provided with a lockable panel. It can be locked by moving the

catch as per g. 7.

Fig. 8.

The radiator is provided with an overheating device, which disconnects the power

if it becomes too hot, e.g. if covered. To reset, push in the reset button in the hole

under the Myson plate on the thermostat housing, see g. 8. If tripping continues

check that no parts of the radiator are covered. Otherwise contact your supplier.

MaIntEnancE

When cleaning or wiping, only use mild detergent.

MIscEllanEous

WARNING - In order to avoid overheating, do not cover the heater. ”Do

not cover” means that the radiator must not be used for drying clothes

etc. by placing them directly on it.

This radiator is lled with a precise amount of special oil, and therefore repairs

that need it to be opened must only be carried out by the manufacturer or their

service representative. In the event of leakage, contact your supplier or their

representative.

This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or instruction concerning

use of the appliance by a person responsible for their safety. Children should be

supervised to ensure that they do not play with the appliance.

If the supply cord is damaged, it must be replaced by the manufacturer, its service

agent or similarly qualied persons in order to avoid a hazard.

When scrapping the heater, follow the regulations concerning the disposal of oil.

aftEr salEs sErvIcE

We guarantee your Myson Finesse for 10 years from date of purchase (except

electrical components which are 2 years from date of purchase) and undertake

to exchange or repair free of charge within this period any part found to be

defective. Should you require after sales service, please complete and return the

enclosed warranty and care card.

Waste disposal according to the Weee directive (2002/96/ec)

The symbol on the product label indicates that the product may not be handled as domestic waste, but must be sorted separately. When it reaches

the end of its useful life, it shall be returned to a collection facility for electrical and electronic products. By returning the product, you will help to pre-

vent possible negative effects on the environment and health to which the product can contribute if it is disposed of as ordinary domestic waste. For

information about recycling and collection facilities, you should contact your local authority/municipality or refuse collection service or the business

from which you purchased the product. Applicable to countries where this Directive has been adopted.