NEUTRIK NAC3FX-W User manual

EU DECLARATION OF CONFORMITY
1. Product model: MSPF-SH-A-7
2. Name and address of the manufacturer or his authorised representative:
MAGICSHOOT
Reigerstraat 110
2025 XG Haarlem
The Netherlands
www.magicshoot.nl
3. This declaration of conformity is issued under the sole responsibility of the manufacturer (or
installer).
4. Object of the declaration:
Equipment:
Powercable; International Extension Cord 16 A / 230VAC; constructed with: 7 meter Titanex H07RN-F
3G1,5mm2black cable and two connectors: Neutrik powerCON TRUE1 NAC3FX-W KERAF 621 Schuko.
Brand name: MagicShoot Cable
Model/type: MSPF-SH-A-7
5. The object of the declaration described above is in conformity with the relevant Union
harmonisation legislation:
Low Voltage Directive (LVD) 2014/35/EU,
Restriction of Hazardous Substances (RoHS) Directive 2011/65/EU,
Directive 2008/98/EC on waste (Waste Framework Directive)
6. References to the relevant harmonised standards used or references to the other technical
specifications in relation to which conformity is declared:
LVD: NEN 3140+A1
RoHS: EN 50581:2012
7. Signed for and on behalf of:
Manufacturer: MagicShoot (phone: [phone] email: [e-mail])
Place and date: Haarlem, 16-02-2017
Sitan van Sluis, Managing Director

International Extension Cord 16 A / 230VAC
Plug / end termination
Neutrik NAC3FX-W / KERAF Schuko
Conductor size
3 x 1,5 mm2
Cable type / color / Nom. O.D.
Titanex H07RN-F3G1.5 / black / 9,6 mm
Part Number
MSPF-SH-A-7
Length
7 m
Class
I
Partnumbering information
(following Neutrik part numbering)
MagicShoot partnumber for two meter cable: MSPF-SH-A-2
SH = schucko

Schucko KERAF

Neutrik nac3fx-w

User Manual
International Extension Cord (powercable)for 230VAC / 16A
Push and rotate the Neutrik connector NAC3MX-W in a corresponding contra connector or chassis-
part until the connector locks. Push yellow button and rotate until the connector unlocks, then pull
out the connector.

Technical Drawing
Is this drawing molded connectors are used. We use non-molded connectors assembled according
the assembly instructions on Neutrik see below.

Production/assembly information

Addition: we use cable end busses and a Knipex crimping tool: 97 53 04

Testing:
The cable is tested according to NEN3140:
-Visual inspection
-Measure electrical values of the cable:
Measurment device used: Nieaf-Smitt EasyPat 250V NEN3140 apparaattester
Resistance protective layer (minimal: 1 MΩ)
Resistance protective conductor ( maximal: 0,3Ω )
Max leaking current: 1mA