NEUTRIK opticalCON User manual

NEUTRIK AG NEUTRIK (UK) Ltd. NEUTRIK USA INC. NEUTRIK Tokyo Ltd. NEUTRIK France NEUTRIK Vertriebs GmbH NEUTRIK HONG KONG
Liechtenstein Great Britain USA Japan France Germany/Netherlands/Austria Hong Kong
Tel.: [phone] Tel.: [phone] Tel.: [phone] Tel.: [phone] Tel.: [phone] Tel.: [phone] Tel.: [phone]
www.neutrik.com
Draft. Nr.: BDA 256
Update: 12.06.2012
Data subject to change without prior notice. ©2012 NEUTRIK . ALL RIGHTS RESERVED.
NAOBO components
cable tie
2 screws
opticalCON chassis
connector (not included)
NAOBO housing
counter nut
90° rear-shell (use for 90° mount)
PG-gland
STRAIGHT mount
90° mount
Screw NAOBO housing and the PG-
gland together.
90° mount
Don't forget the 90° degree rear-shell .







Handling Instruction
opticalCON |NAOBO

www.neutrik.com Page 2/2
Neutrik AG |Im alten Riet 143 | 9494 Schaan | Liechtenstein
T [phone] | F [phone] | [e-mail] | www.neutrik.com
Guide all LC cables carefully through the
NAOBO housing .
ATTENTION: Make sure that the dust
caps cover the LC-ferrules.
Remove dust caps and connect the LC
cables to the rear side of the opticalCON
chassis connector and mount chassis
With help of the screws .
Tighten PG-gland to reduce inner
diameter of the insert and achieve a
correct cable retention.
Use cable tie to attach NAOBO to
equipment (e.g. rack), rigs, etc.
fastening thread