NEUTRIK NE8FDY-C6 User manual

Twist the
screen
8-9 mm
40 mm
2. 3. 4. 5.
Cable tie
ASSEMBLY INSTRUCTION
NE8FDY-C6 etherCON Receptacle
|
R
Page 1BDA 188
DCable mount
B
S-FTP SF-UTP F-UTP
Shielding
EPosition wires acc. label FFix wires
1.
ACable preparation
CCable pairs separation
8 7 4 5 6 3 2 1
568 B
568 A
87 45 63 21
1. The correct order of
wires is shown on the
sticker on the wire
management system.
2. Insert the wires into
the designated position
of the wire management
according to standard
TIA 568A or TIA 568B.
2.
1.
Trimming!

G H
Break out!
Cut!
K
I J
Press
down!
Snap in
Hang up!
NOTE for Right-Angle Version
Working steps same as above.
Except:
Step B - References to step B and bend
the reinforcement metal right
angle below.
Step G - The cable outlet must not be
interrupted.
1.
2.
Cover assembly Connect the screen
Assembly the adapter Grounding option
Assembly the chassis
Please fix the cable additionally.Attention: Before assembly secure the housing in the device.
B
G
Insert until it
snaps in
Insert contact only if screen should
be connected to front panel
LFinish
ASSEMBLY INSTRUCTION NE8FDY-C6
I
Page 2
www.neutrik.com
NEUTRIK AG LI T: +423 / 237 24 24 F: +423 / 232 53 93
NEUTRIK USA Inc. USA T: +1 704 / 972 3050 F: +1 704 / 438 9202
( )
NEUTRIK UK Ltd. UK T: +44 1983 / 811 441 F: +44 1983 / 811 439
NEUTRIK Vertriebs GmbH DE / NL / AT/DK T: +49 8131 / 280 890 F: +49 8131 / 280 830
NEUTRIK France FR T: +33 1 / 4131 6750 F: +33 1 / 4131 0511
NEUTRIK Tokyo Ltd. JP T: +81 3 / 3663 4733 F: +81 3 / 3663 4796
NEUTRIK Hong Kong Ltd. HK T: +852 / 2687 6055 F: +852 / 2687 6052
NEUTRIK India Pvt. Ltd. IND T: +91 / 982 05 43 424 F: +91 / 22 26163 540
R
Draft. Nr.: BDA 188 Update: 30.09.2015 Data subject to change without prior notice. 2015 NEUTRIK . ALL RIGHTS RESERVED. NEUTRIK are registered trademark.
I I ® ®
©