Nokia CR-102 User manual

Nokia Holder Easy Mount HH-12
& Nokia Mobile Holder CR-102
9209691/1

© 2008 Nokia. All rights reserved.
Nokia, Nokia Connecting People and the Nokia Original Accessories logo are registered
trademarks of Nokia Corporation.
Introduction
The Nokia Holder Easy Mount HH-12 is a mounting device that
allows you to attach your compatible Nokia mobile holder to the
windscreen of your vehicle.
To use the mounting device with your compatible mobile holder, attach
the mounting device to the windscreen, adjust the mounting device
into the desired position, and attach your mobile holder to the
mounting device.
This product may contain small parts. Keep them out of the reach of
small children.
General safety instructions
Obey all local laws. Always keep your hands free to operate the vehicle
while driving. Your first consideration while driving should be road
safety. Only operate the mounting device or mobile holder if it is safe
to do so under all driving conditions.

ENGLISH
When you install the mounting device or mobile holder, ensure that
they do not interfere with or hinder the steering or braking systems
or other systems used in the operation of the vehicle (for example,
airbags) or disturb your field of vision while driving.
Check that the deployment of the airbag is not blocked or impaired in
any way.
Ensure that the mounting device or mobile holder is not installed
where you might come in contact with it in the event of an accident
or collision.
Periodically check that the suction cup at the bottom of the
mounting device is firmly attached to the windscreen, especially if
the ambient temperature changes a lot.
Never leave the mounting device inside the vehicle in direct sunlight
or in excessive heat. The mounting device and suction cup may be
damaged and adhesion may be impaired if the inside temperature
exceeds +70°C (160°F).

ENGLISH
Attach to a windscreen
Locate a safe mounting surface on the windscreen, and clean the
surface thoroughly with a glass cleaner and a clean towel. If the
ambient temperature is below +15°C (60°F), carefully warm the
surface and the suction cup with a hair dryer to ensure a firm grip
on the windscreen. Ensure that you do not heat the windscreen
excessively to avoid damage to it.
Press the suction cup at the bottom of the
mounting device firmly on the windscreen
(see step 1 at the start of this guide), and
carefully push the locking lever inside the
mounting device (2) towards the suction cup
to create a vacuum between the suction cup
and the windscreen. Check that the suction
cup is firmly attached.

ENGLISH
To detach the mounting device from the
windscreen, carefully push the locking lever
toward the top of the mounting device (3),
and pull the strap located on the edge of the
suction cup (4).
Set to the desired position
Do not adjust the mounting device while driving.
To set the top of the mounting device to the
desired position, loosen the two screws in the
middle of the mounting device, turn the top
to the desired position, and tighten the
screws (5). Ensure that the top of the device
is firmly locked into place.
To set the mounting plate at the top of the
mounting device to the desired position, loosen the screw below the
plate, turn the plate to the desired position, and tighten the screw (6).

ENGLISH
Mount the mobile holder
To attach a compatible Nokia mobile holder to the mounting plate,
use the screw supplied with the holder.
To use the CR-102 mobile holder, remove the protection plate with
the Nokia text from the holder, use a screwdriver to attach the holder
to the mounting plate with the supplied screw, and replace the
protection plate (7). To insert your mobile device into the holder, push
the catch at the top of the holder (8), and slide the device into the
holder until it locks into place (9). To remove the device, push the
catch (10), and pull the device out (11).

ENGLISH
When attaching a mobile holder, ensure that the display of the
mobile device is clearly visible for the user. For your safety, install
the holder in the upright position.
Care and maintenance
Your device is a product of superior design and craftsmanship and
should be treated with care. The following suggestions will help you
protect your warranty coverage.
• Do not use or store the device in dusty, dirty areas. Its moving
parts can be damaged.
• Do not drop, knock, or shake the device. Rough handling can break
fine mechanics.
• Do not use harsh chemicals, cleaning solvents, or strong
detergents to clean the device.
• Do not paint the device. Paint can clog the moving parts and
prevent proper operation.
If the product is not working properly, take it to the nearest
authorised service facility for service.

Notes

Soporte de Fácil Montaje
Nokia HH-12 y Soporte Móvil
Nokia CR-102
9209691/1

© 2008 Nokia. Todos los derechos reservados.
Nokia, Nokia Connecting People y el logo de Nokia Original Accessories son marcas
registradas de Nokia Corporation.
Introducción
El Soporte de Fácil Montaje Nokia HH-12 es un dispositivo de
montaje que le permite instalar su soporte móvil Nokia compatible
en el parabrisas de su vehículo.
Para usar el dispositivo de montaje con su soporte móvil compatible,
instale el dispositivo de montaje en el parabrisas, ajústelo en la posición
deseada y coloque el soporte móvil en el dispositivo de montaje.
Este producto puede contener partes pequeñas. Manténgalas fuera
del alcance de los niños.
Instrucciones generales de seguridad
Obedezca las leyes locales. Mantenga siempre las manos libres para
maniobrar el vehículo mientras conduce. La seguridad vial debe ser
su prioridad cuando conduce. Sólo utilice el dispositivo de montaje o
el soporte móvil si es seguro bajo todas las condiciones de conducción.