Nokia BH 212 - Headset - Over-the-ear User manual

Nokia Bluetooth Headset BH-212
9210666/2

ENGLISH
DECLARATION OF CONFORMITY
Hereby, NOKIA CORPORATION declares that this HS-112W product is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of
Conformity can be found at http://www.nokia.com/phones/declaration_of_conformity/ .
© 2008 Nokia. All rights reserved.
Nokia, Nokia Connecting People and the Nokia Original Accessories logo are registered trademarks of
Nokia Corporation. Other product and company names mentioned herein may be trademarks or
tradenames of their respective owners.
Reproduction, transfer, distribution, or storage of part or all of the contents in this document in any
form without the prior written permission of Nokia is prohibited.
Bluetooth is a registered trademark of Bluetooth SIG, Inc.
Nokia operates a policy of ongoing development. Nokia reserves the right to make changes and
improvements to any of the products described in this document without prior notice.
To the maximum extent permitted by applicable law, under no circumstances shall Nokia or any of its
licensors be responsible for any loss of data or income or any special, incidental, consequential or
indirect damages howsoever caused.
The contents of this document are provided "as is". Except as required by applicable law, no warranties
of any kind, either express or implied, including, but not limited to, the implied warranties of
merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or
contents of this document. Nokia reserves the right to revise this document or withdraw it at any time
without prior notice.
The availability of particular products may vary by region. Please check with your Nokia dealer for details.

ENGLISH
Export controls
This device may contain commodities, technology or software subject to export laws and regulations
from the US and other countries. Diversion contrary to law is prohibited.
Introduction
With the Nokia Bluetooth Headset BH-212, you can make and receive calls while on the
move. You can use the headset with compatible mobile phones that support Bluetooth
wireless technology.
Read this user guide carefully before using the headset. Also, read the user guide for
your phone.
This product may contain small parts. Keep them out of the reach of small children.
Bluetooth wireless technology
Bluetooth wireless technology allows you to connect compatible devices without cables.
The phone and the headset do not need to be in line of sight, but they should be within
10 metres (33 feet) of each other. Connections may be subject to interference from
obstructions, such as walls, or other electronic devices.
The headset is compliant with the Bluetooth Specification 2.0 + EDR supporting the Headset
Profile 1.1 and Hands-Free Profile 1.5. Check with the manufacturers of other devices to
determine their compatibility with this device.

ENGLISH
Get started
The headset contains the following parts shown on the title page: volume key (1),
multifunction key (2), indicator light (3), charger connector (4), earpiece (5), and
microphone (6).
Before using the headset, you must charge the battery and pair the headset with a
compatible phone.
Parts of the device are magnetic. Metallic materials may be attracted to the device. Do not
place credit cards or other magnetic storage media near the device, because information stored
on them may be erased.
Chargers
This device is intended for use when supplied with power from the following chargers: AC-3,
AC-4, AC-5, and DC-4.
Warning: Use only chargers approved by Nokia for use with this particular
enhancement. The use of any other types may invalidate any approval or warranty,
and may be dangerous.
When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord.
Charge the battery
Before charging the battery, carefully read “Battery information” .
1. Connect the charger to a wall outlet.
2. Connect the charger to the headset (7). During charging, the red indicator light is on
and the headset cannot be used. Charging the battery fully may take up to 2 hours.

ENGLISH
3. When the battery is fully charged, the green indicator light is displayed.
Disconnect the charger from the headset and the wall outlet.
If the headset was connected to your phone before charging, the headset connects
to it again.
The fully charged battery has power for up to 11 hours of talk time or up to 500 hours of
standby time.
When the battery is discharged, the headset beeps every minute and the red indicator
light flashes quickly.
Switch on or off
To switch on, press and hold the multifunction key for about 2 seconds. The headset beeps,
and the green indicator light is displayed. The headset tries to connect to a paired phone.
To switch off, press and hold the multifunction key for about 5 seconds. The headset
beeps, and the red indicator light is briefly displayed.
Pair the headset
1. Ensure that your phone is on and the headset is off.
2. Press and hold the multifunction key (for about 5 seconds) until the green indicator
light starts to flash quickly.
3. Activate the Bluetooth feature on the phone, and set it to search for Bluetooth devices.
4. Select the headset from the list of found devices.
5. Enter the passcode
0000 to pair and connect the headset to your phone. In some
phones, you may need to make the connection separately after pairing.

ENGLISH
If the pairing is successful, the headset appears in the phone menu where you can view
the currently paired Bluetooth devices.
When the headset is connected to your phone and is ready for use, the green indicator
light flashes slowly.
Basic use
Place the headset on the ear
Place the headset over your ear, and slide it downwards (8). Gently push the earpiece
into your ear. Point the headset toward your mouth (9).
Calls
To make a call, use your phone in the normal way when the headset is connected to it.
To redial the number you last called (if your phone supports this feature with the
headset), when no call is in progress, press the multifunction key twice.
To activate voice dialling (if your phone supports this feature with the headset), when
no call is in progress, press and hold the multifunction key for about 2 seconds. Proceed
as described in the phone user guide.
To answer or end a call, press the multifunction key. To reject a call, press this key twice.
To adjust the volume during a call, slide the volume key up or down.
To mute or unmute the microphone during a call, briefly press the middle of the volume key.

ENGLISH
To switch a call from the headset to a compatible phone, press and hold the multifunction
key for about 5 seconds (the headset switches off). To switch the call back to the headset,
press the multifunction key for about 2 seconds (the headset switches on).
Clear settings or reset
To delete the pairings from the headset or reset the headset, switch off the headset, and
press and hold the multifunction key for over 8 seconds. The headset beeps twice, and
the red and green indicator lights alternate 5 times.
Troubleshooting
If you cannot connect the headset to your compatible phone, check that the headset is
charged, switched on, and paired with the phone.
Battery information
This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove
the battery from the device as you may damage the device. The battery can be charged and
discharged hundreds of times, but it will eventually wear out. Recharge your battery only with
Nokia approved chargers designated for this device. Use of an unapproved charger may present
a risk of fire, explosion, leakage, or other hazard.
If a battery is being used for the first time or if the battery has not been used for a prolonged
period, it may be necessary to connect the charger, then disconnect and reconnect it to begin
charging the battery. If the battery is completely discharged, it may take several minutes before
the charging indicator light is displayed.

ENGLISH
Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully
charged battery connected to a charger, since overcharging may shorten its lifetime. If left
unused, a fully charged battery will lose its charge over time.
Always try to keep the battery between 15°C and 25°C (59°F and 77°F). Extreme temperatures
reduce the capacity and lifetime of the battery. A device with a hot or cold battery may not work
temporarily. Battery performance is particularly limited in temperatures well below freezing.
Do not dispose of batteries in a fire as they may explode. Batteries may also explode
if damaged.
Never use any charger that is damaged.
Important: Battery talk and standby times are estimates only and depend on
network conditions, features used, battery age and condition, temperatures to
which battery is exposed, and many other factors. The amount of time a device is
used for calls will affect its standby time. Likewise, the amount of time that the
device is turned on and in the standby mode will affect its talk time.
Care and maintenance
Your device is a product of superior design and craftsmanship and should be treated with care.
The following suggestions will help you protect your warranty coverage.
• Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can
contain minerals that will corrode electronic circuits. If your device does get wet, allow
it to dry completely.

ENGLISH
• Do not use or store the device in dusty, dirty areas. Its moving parts and electronic
components can be damaged.
• Do not store the device in hot areas. High temperatures can shorten the life of electronic
devices, damage batteries, and warp or melt certain plastics.
• Do not store the device in cold areas. When the device returns to its normal temperature,
moisture can form inside the device and damage electronic circuit boards.
• Do not attempt to open the device.
• Do not drop, knock, or shake the device. Rough handling can break internal circuit boards
and fine mechanics.
• Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device.
• Do not paint the device. Paint can clog the moving parts and prevent proper operation.
These suggestions apply equally to your device, charger, or any enhancement. If any device is
not working properly, take it to the nearest authorised service facility for service.

ENGLISH
Disposal
The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds
you that all electrical and electronic products, batteries, and accumulators must be
taken to separate collection at the end of their working life. This requirement applies
to the European Union and other locations where separate collection systems are
available. Do not dispose of these products as unsorted municipal waste.
By returning the products to collection you help prevent uncontrolled waste disposal
and promote the reuse of material resources. More detailed information is available from
the product retailer, local waste authorities, national producer responsibility
organizations, or your local Nokia representative. For the product Eco-Declaration or
instructions for returning your obsolete product, go to country-specific information
at
www.nokia.com .