NOMA 043-5999-2 User manual

OSCILLATING RADIANT HEATER
Instruction Manual
model no. 043-5999-2
Toll-free 1-866-827-4985
IMPORTANT: Please read this manual carefully
before running this heater and save it for reference.
O
I
II

2
model no. 043-5999-2 | contact us 1-866-827-4985
Table of Contents
Specifications 2
Packaging Contents 2
Product Diagram 3
Operation 4
Cleaning and Maintenance/Safety Features 6
Important Safeguards 8
Warranty 10
Specifications
Packaging Contents
Model 043-5999-2
Voltage 120 V AC / 8.33 A
Frequency 60 Hz
Settings High 1000 W, Low 700 W
1. Infrared Heater
2. Instruction Manual

3
O
I
II
Product Diagram
• O - OFF
• I - LOW Heat (700 W)
• II - High Heat (1000 W)
• Oscillation Function Works in
Both HIGH and LOW Settings
A. Stay-cool Moulded Handle
B. 3-position Rotary
Dial Control
C. Oscillation Funtion
Control
A
B C
O
I
II

4
model no. 043-5999-2 | contact us 1-866-827-4985
PREPARATION
Place the heater on a firm, level surface.
Plug into a grounded, 120 V (60 Hz) power
outlet.
!WARNING:
This heater has a voltage rating of 120 V. The polarized plug should
be connected to a properly grounded three prong outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THE POLARIZED PLUG.
WARNING: It is normal for the power cord to feel warm to the touch;
however, a loose fit between the outlet and the plug may cause
overheating of the plug. If the plug is loose, do not use this outlet. Rather,
try inserting the plug into a dierent outlet. Contact a qualified electrician
to inspect the original outlet.
!
POLARIZED
PLUG
COVER OF GROUNDED
OUTLET BOX
Operation
model no. 043-5999-2 | contact us 1-866-827-4985

O
I
II
HEATER OPERATION
Always operate the heater in the upright position following all instructions and
recommendations listed in this manual. HEATER LOCATION: Place the heater in the
area of the room that is coldest. HEATER CONNECTION: Plug heater directly into
120 V AC, 60 Hz wall outlet. Be sure plug fits tightly in outlet. A loose connection may
cause overheating and damage to the plug or heater. NOTE: The heater draws 8.33 A
during operation. To prevent overloading a circuit, do not plug the heater into a circuit
that is servicing other electrical needs.
OPERATION SWITCH
This heater has two heat settings:
I(Low –700 W) and II (High –1000 W). Use the II (High) setting to raise the room
temperature quickly. When the desired temperature is reached use the I (LOW)
setting to maintain temperature. It is usually sucient to maintain a
comfortable temperature.
TILT FEATURE
Your heater can tilt for adjusting the direction of heat. To adjust the
angle, loosen tilt adjustment knob and move angle of the heater to desired
position. Tighten tilt adjustment knob to hold heater in position. Do not force
the heater in either direction beyond its guides.
TURNING OFF
Turn the selector switch to the
“O” (OFF) position before unplugging or plugging
in the heater. Heater should be unplugged when
not in use.
OSCILLATION CONTROL
You can turn the oscillation feature on
the heater on by rotating the oscillation control
switch (right knob) to position.
TURNING HEATER ON
To start the heater, turn the POWER SWITCH (left
knob) from the O(OFF) position to the I
(Low –700 W) or II (HIGH –1000 W) position.
During the heater’s initial use, you may experience a
slight odour or smoking. This is the result of the
heating element lubrication “burning o”. This is
normal and will go away after a few minutes of use.
5
Power
Switch
Oscillation
Switch
Non-glowing coils Glowing coils
Operation

6
model no. 043-5999-2 | contact us 1-866-827-4985
CLEANING:
CAUTION: Before cleaning the heater, be sure to disconnect power cord and allow the
heater to cool completely. This heater should be cleaned at least once a year to
maintain proper performance. Clean the outside surface with a clean, damp cloth.
Do not use harsh chemical or abrasive cleaners.
DO NOT IMMERSE THE HEATER IN WATER. Allow heater to dry completely before use.
REPAIR:
DO NOT OPERATE THE HEATER WITHOUT THE GRILLE IN PLACE. DO NOT USE THE
HEATER IF IT HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
STORAGE:
Keep original carton for storage of the heater. Coil and tie the power cord to avoid
damage during storage.
Cleaning and Maintenance
IMPORTANT SAFETY FEATURES:
The heater is equipped with an automatic overheat protection device and an
automatic tip-over sensor located under the base of the heater. If the heater grille
is obstructed, the automatic overheat device will turn the heater o. If the heater is
tipped over, the automatic tip-over switch will turn o the heater. If either safety
sensor is activated, make sure the heater is on a level surface and clear of all
obstacles. Unplug the heater and allow it to cool down. Restart the heater once it has
cooled down and obstacles have been removed.
Safety Features

7
INTENDED USE:
This product is intended for indoor residential and oce use only, not for industrial or
other commercial application. Use only with electrical wiring that is in good working
order and that meets applicable codes and ordinances. This heater must be plugged in to
a 120 V AC, 15 A (or larger) circuit. Do not plug anything additional into the same circuit.
If you have any questions whether your wiring is adequate, consult a qualified electrician.
Risk of fire, overheating, malfunction, property damage, injury or even death may result if
not adhered to.
Use your heater only with a working smoke detector located in the vicinity of your heater.
While using your heater, you should follow the IMPORTANT INSTRUCTIONS listed
below. As part of those instructions, we have used the word “WARNING” to indicate the
level of hazard: “WARNING” indicates a hazard which, if not avoided, could result in injury
or death.
IMPORTANT INSTRUCTIONS:
When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electric shock and injury to persons, including the following:
1. Read all the instructions before using this heater/fan.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfac-
es. Use provided handle when moving this heater. Keep combustible materials, such
as furniture, pillows, bedding, papers, clothes and curtains at least 3’ (0.9 m) from the
front of the heater-fan and keep them away from the sides and rear.
3. Do not use heater unattended. Use of extreme caution is necessary when any heater
is used by or near children, invalids, disabled persons or pets.
4. Do not operate the heater with a damaged power cord or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or mechanical adjustment or repair.
5. Do not use heater outdoors.
6. Use your heater only in dry environments. This heater is not intended for use in a
bathroom, laundry area, or similar locations, or near sinks, washing machines,
swimming pools or other sources of water. Never locate heater where it may fall into
a bathtub or other water container. Do not use in damp environments such as
flooded basements.
7. Do not place the heater on a small, unlevel, uneven surface or any surface which
might allow heater to tip or fall.
8. For proper operation, heater should be placed on a smooth, non-combustible
surface. Do not place on rugs, carpet, vinyl flooring or other plastic surfaces. Not for
use outdoors or in wet areas.
9. This heater is not designed as a primary heat source.
Important Safeguards

8
Important Safeguards
model no. 043-5999-2 | contact us 1-866-827-4985
Important Safeguards
10. Always plug heaters directly into a wall outlet/receptacle. Never use with an
extension cord or relocatable power tap (outlet/power strip). Always unplug heater
when not in use.
11. Do not run power cord under carpeting. Do not cover cord with throw rugs, runners or
similar coverings. Arrange cord away from trac area where it will not be tripped over.
12. To disconnect heater, turn controls o then remove plug from outlet.
13. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause an electric shock or fire or damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surfaces like a bed, where openings may become blocked.
15. A heater has hot and arcing or sparking parts inside. Do not use it in areas where
gasoline, paint or flammable liquids are used or stored.
16. Use this heater only as described in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock or injury to persons or property.

9
WARNING: SHOCK HAZARD
Use your heater only in dry environments. This heater is not intended for use in a
bathroom, laundry area, or similar locations, or near sinks, washing machines, swimming
pools or other sources of water. Never locate heater where it may fall into a bathtub or
other water container. Do not use heater outdoors. Do not use in damp environments
such as flooded basements.
WARNING: HOT SURFACES
Do not touch body of heater when in use. This heater is hot when in use, to avoid
burns, do not let bare skin touch hot surfaces. If provided, use handles when moving
this heater.
WARNING: FIRE HAZARD
Heater has hot and arcing or sparking parts inside. Do not use near combustible
materials or flammable gases or sources of heat. DO NOT USE in areas where gasoline,
paint or flammable materials are used or stored. Keep combustible materials such as
furniture, pillows, bedding, papers, clothes and curtains at least 3’ (0.9 m) from the front
of the heater and keep them away from the sides and rear. To prevent a possible fire, do
not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed,
where openings may become blocked. Do not place the heater near a bed because
objects such as pillows or blankets can fall o the bed and be ignited by the heater. Do
not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock, fire, or damage the heater.
WARNING: ELECTRIC SHOCK HAZARD
Do not use with damaged cord or plug. Use with adequate electrical system that is
up to code.
The supply cord has a polarized plug. As a safety feature this plug will fit in a polarized
outlet only one way. To prevent electric shock, match wide blade of plug to wide slot and
fully insert plug. If the plug does not fit, contact a qualified electrician.
Do not operate any heater with a damaged cord or plug, or after heater malfunctions, has
been dropped or damaged in any manner. Do not operate heater with a broken heating
element or ceramic cone or any visual imperfections. For repairs covered under warranty,
see warranty statement. For all other repairs contact by telephone or mail for information
and assistance.
PET OWNERS NOTE:
The health of birds and some small pets are extremely sensitive to the fumes given o
during the initial use of many appliances. Although these fumes are not harmful to
humans, it is recommended that this heater not be used around birds and small pets dur-
ing its initial use until the manufacturing corrosion coatings burn o.
Important Safeguards

10
model no. 043-5999-2 | contact us 1-866-827-4985
LIMITED 1YEAR WARRANTY
This product carries a one (1) year warranty against defects in workmanship and
materials. NOMA Canada agrees to replace a defective product, within the stated
warranty period, when returned to the place of purchase with proof of purchase.
This product is not guaranteed against wear or breakage due to misuse and/or abuse.
Imported by NOMA Canada, Toronto, Canada M4S 2B8
Made in China
Warranty