NRS Healthcare N10699 User manual

Extra Wide Commode Range
General Safety Warning
Please ensure these instructions are fully read and
followed. Failure to do so may result in injury to
the user. Retain these instructions in a safe place
for future reference.
Intended Use
The Extra Wide Commode Range is primarily intended
to be used as a commode for toileting. It may also be
used as a seat support over a standard toilet (with
backrest and existing toilet seat removed) and, when
the seat cover is fitted, as a short duration bedroom
seat/chair or for occasional use in a shower. Side
transfers are possible with N10717 - removable arm
version. The seat height is adjustable on all variants.
Unpacking
Remove all parts from packaging, Check all parts are
present, refer to contents list below. Check for
damage. If you see, or suspect a fault, do not use the
product and contact your supplier.
Contents List
Item Description N10699 N10705 N10717
1 Commode Frame 1 1 1
2
Toilet Seat
1
1
1
3
PU Seat Cover
1
1
1
4 Potty 1 1 1
5
Potty Lid 1 1 1
6
Backrest 1 1 1
7
Leg 4 2 2
8 Leg/wheel Assy LH - 1 1
9
Leg/wheel Assy RH - 1 1
10
Removable Arm
(not shown ) - - 2
11
Seat Fixing Screw
(not shown ) 2 2 2
12
Seat Fixing Nut
(not shown )
2
2
2
13
Washer
(not shown)
2
2
2
14 E- Clip 4 4 8
N10699 Fixed Arms
-
550mm wide
N10705 Fixed Arms - 660mm wide
N10717 Removable Arms
-
660mm wide
User Instructions
Maximum
User Weight
Assembly
Instructions
·With the frame upturned, fit the legs, at the
required height, using the e-clips provided.
·For N10699 fit all four legs. For N10705 &
N10717 fit the two legs without wheels to one
side of the commode frame; then fit the legs with
wheels to the other side of the frame with the
wheels in the orientation as shown in the picture
above. Turn the commode onto its legs and
check the legs are at the same height and the
frame does not rock.
·To fit the toilet seat first unclip the plastic cover
on the seat hinges to reveal the fixing holes
·Align the seat fixing holes with the holes in the
frame.
·Place a washer on each fixing screw, and insert
them through the holes; secure from the other
side with the nuts provided. Note: the seat must
be secure, but do not over tighten the nuts.
·Clip the plastic covers back to the hinge, to cover
the screws.
·Fit the backrest in the desired position. Tip: the
backrest slides more easily into position if both
tubes are pushed into the frame at the same time
until the button clip engages to secure in place.
The backrest has three seat depth settings, to
move further inwards, depress the spring button
clips and push the backrest further into the frame.
·Slide the potty into the commode, from the front,
using the rail wires on the underside of the frame
·Place the potty lid on the potty if required
·Fit the PU seat cover over the toilet seat.
N10717 only
·Fit the removable arms, using the e-clips
provided, as shown in the picture above.
2
1
3
4
5
6
7
8
9
1
1

Product Care: Cleaning General
·To help reduce the risk of infection as well as
keeping the commode clean and odour
free, it is recommended a sanitising spray or
cloth is used to wipe down the potty,
commode seat and arms after every use.
·Carers should always wear protective gloves
when carrying out these tasks.
Product Care: Cleaning the Commode Potty
·After every use rinse the potty thoroughly with
warm water, ensure there is no residue, clean
with a mild disinfectant.
·Use of sanitising sprays or cloths is
recommended
Product Care: Cleaning the Commode Frame
·Clean the frame regularly, at least on a weekly
basis, with a mild disinfectant solution.
·This product is also suitable to be cleaned in
commercial high temperature washing
machines.
·Ensure all parts are dried thoroughly before
re-use.
Product Care: Maintenance
·Inspect the product at regular intervals for
signs of wear, damage or possible faults. If
any are found or are suspected, remove from
use immediately and contact your supplier for
advice.
The Extra Wide Commode Range is part of a
range of over 3000 daily living aids available from
NRS Healthcare. To view all of our products
please visit our website: www.nrs-uk.co.uk
or request a catalogue from the number below.
NRS Healthcare
Sherwood House, Cartwright Way
Forest Business Park, Bardon Hill,
Coalville, Leicestershire, LE67 1UB, UK
Tel: [phone]
Email: [e-mail]
www.nrs-uk.co.uk
UI /N10699/N10705/N10717/05/14/Iss1
Safety Precautions
·Ensure an even floor surface to avoid rocking. All
ferrules must be in contact with the floor at all
times.
·Do not exceed the maximum user weight limit.
·It is recommended a risk assessment is carried
out by a healthcare professional with regard to the
environment and capabilities of the user.
·Inspect at regular intervals for damage or
excessive wear, if found, or suspected, remove
from use immediately and contact your supplier.
·Always dispose of the potty contents into a toilet
or sluice.
Instructions for use
·For N10705 and N10717 only: to manoeuvre into
position, tilt onto the wheels by lifting the armrest
and tilting the commode upwards so the wheels
are in contact with the floor and wheel into
position.
·Set the product to the correct height for the client
by removing the e-clips which secure the legs and
slide them to the required height, align the holes in
the leg and frame and secure with the e-clips.
Ensure all legs are at the same height.
·If the product is to be used over a toilet, as shown
below, remove the backrest and ensure the height
is set so all parts of the commode clear the toilet.
You may need to remove the existing toilet seat
also. Ensure the aperture of the commode seat is
positioned centrally over the toilet bowl.
·N10717 Removable arm version: to remove the
arm, unclip the two e-clips which secure the arm
and pull gently upwards. When replacing ensure
both e-clips are re-fitted, and the arm is stable.
·When using the potty, slide fully into position from
the front. To help contain odours fit the potty lid
when transporting.
·Always dispose of the potty contents into a toilet
or sluice.
Toilet Fitting