
3500 Corporate Parkway, PO BOX 610, Center Valley, PA 18034
For more information, contact your Olympus
sales representative, or call 800-848-9024.
www.medical.olympusamerica.com
©2022 Olympus America Inc. All rights reserved.
Printed in USA OAIENT0422QRG43721
Manufactured by Olympus Surgical Technologies America, 9600 Louisiana Ave. North Brooklyn Park, MN 55445.
Olympus is a registered trademarks of Olympus Corporation, Olympus America Inc., and/or their afliates. | Medical devices listed may not be available for sale in all countries.
CELERIS System Set-up and Operation (continued)
CELERIS™System Set-up and Operation
Quick Reference Guide
2
Plug the Sinus Debrider
power cord into the
CELERIS Reusable
Power Pack and ensure
that the green light
is illuminated.
Connect the suction
tubing to the suction port
luer fitting on the back of
the debrider.
(Optional) If using Diego
Elite, Suction Module,
connect suction module
to the DB9 connector on
the Power Pack.
3
4
Connect the Bipolar cord to the RF generator* (if applicable).
5
(Optional) Connect the InstaClear™ footswitch
to the Power Pack if using a footswitch.
6
Press the cut trigger (or footswitch) to activate the Sinus Debrider.
*Inspect the cable and insulation prior to use. Insulation failure may result in burs or other injuries to the patient or user.
Only make connections while the energy is off. Failure to do so may result in an injury or electrical shock to the patient or user.
Refer to generator’s instruction manual for detailed setup instructions.
CAUTION:
This guide is only a summary of the instructions for use for CELERIS Disposable Sinus Debrider. Be sure to follow the Olympus instruction manual that
was included in the device package.