OmniPrint DIRECT HEAT User manual

DIRECT HEAT
Official User Manual
2021 Edition
Vacumm Platen

What’s Included .............................................................................3
Direct Heat Vacuum Platen Specifications .................................4
Direct Heat Vacuum Platen Safety Instruction ...........................4
Direct Heat Vacuum Platen Safety Marks ...................................5
Controller Thermostat Functions ................................................5
Direct Heat Vacuum Platen Installation ......................................6
Direct Heat Vacuum Platen Operation ........................................7
Anatomy of a Direct Heat Vacuum Platen ...................................8
Table of Contents

[1] Direct Heat Vacuum Platen
with controller thermostat
[1] Power Cord
[2] Hoop & loop cable ties [2] Pedal
What’s Included In The Direct Heat
Vacuum Platen Package:
3

4
Direct Heat Vacuum Platen Specifications
Direct Heat Vacuum Platen Safety Instruction
Size (Unit: mm)
457.2 (L) X 336.55 (W) X 96.266 (H)
Weight:
4.7173 KG
1 Controller Thermostat
1 Power Cord
Read this manual carefully before using this equipment with
your printer.
• Following instructions are to prevent damage to the equipment
or your health.
• Do not use the heating system on flammable or explosive
material.
• Whenever performing maintenance or service, make sure to
switch off the machine and to disconnect the power cable.

5
Direct Heat Vacuum Platen Safety Marks
Controller Thermostat Functions
Down Button: press this button if you need to lower the set temperature.
Up Button: press this button if you need to raise the set temperature.
Timer Button:
Power Button: This button ONLY turns the controller on and off, make sure
to turn it off first before turning off the direct heat vacuum plate completely.
The caution sign on the
machine indicates points
where the operator needs to
take special care during
operation.
• The surface heats up
gradually.

6
Direct Heat Vacuum Platen Installation
1. Place the Direct Heat
Vacuum Platen on the Freejet
printer.
2. Carefully pass the control
back and move the gantry
forward.
3. On the back side, connect
the power cord.
4. Attach the two Hoop and
loop cable ties and cable tie
mounts as shown in the
picture to hold the power
cord and thermostat
controller cable.
5. Place the control on the
printer.
6. Connect the power cord to
power outlet.

7
Direct Heat Vacuum Platen Operation
1. Turn on the controller for
the Direct Heat Vacuum
Platen.
2. Turn on the controller.
3. Set the temperature on the
control to the one that best
suits your need (it is
recommended to start with a
temperature of 40° C).

8
Fig 1 - Rear View of Direct Heat Vacuum Platen.
Fig 2- Side View of Direct Heat Vacuum Platen.
Anatomy of a Direct Heat Vacuum Platen