Onespace 50-SH01DW User manual

LARGE CORNER WALL MOUNT SHELF, DARK WALNUT
ASSEMBLY INSTRUCTIONS
MODEL 50-SH01DW
SUPPLIER CODE: SPRG
OneSpace is a Trademark of Comfort Products, Inc.
™

2 of 6
Shelf maximum
weight capacity
=
10lbs

HARDWARE KIT
STOCK # 51-SH01DWHA
PART DESCRIPTION QTY
STOCK NO
3 of 6
REPLACEMENT PARTS
IF YOU ARE MISSING ANY OF THE PARTS ABOVE, OR IF YOU HAVE A DAMAGED PART, PLEASE VISIT WWW.COMFORTPRODUCTS.NET/SUPPORT.
REFERENCE THE MODEL # ON THE FRONT OF THIS MANUAL. SIMPLY COMPLETE THE INFORMATION, INCLUDING THE PART YOU NEED.
THE PART WILL NORMALLY BE SHIPPED WITHIN 48 HOURS.
- READ THE INSTRUCTION MANUAL BEFORE ASSEMBLING.
- REMOVE ALL PIECES BEFORE BEGINNING INSTALLATION.
- OPEN THE HARDWARE AS NEEDED.
- ASSEMBLE IN AN AREA WITH PLENTY OF SPACE.
- READ EACH STEP BEFORE BEGINNING CONSTRUCTION.
- HAVE THE TOOLS BELOW BEFORE YOU BEGIN ASSEMBLING.
- NEVER FORCE THE SCREWS OR FITTINGS.
- KEEP THIS MANUAL FOR FUTURE REFERENCE.
- TIGHTEN ALL THE SCREWS EVERY 6 MONTHS.
- DO NOT SHIFT OR DRAG THE PRODUCT AFTER ASSEMBLY.
CLEANING AND CARE
- CLEAN SURFACES WITH A DRY OR DAMP CLOTH.
- DO NOT USE ABRASIVE CLEANERS.
- DO NOT USE FURNITURE WAX OR POLISH AS THE UNIT
IS FINISHED WITH A PROTECTIVE CLEAR LACQUER.
2
- THE FOLLOWING TOOLS ARE NOT INCLUDED.
51-SH01DWA
End Board
A
4
51-SH01DWB
Middle Board
B
5
51-SH01DWCShelf
C
PART DESCRIPTION QTY
20
1
22
2
3
20
1
1
4
PARTS AND HARDWARE LIST (50-SH01DW)
EXTRA HARDWARE INCLUDED FOR YOUR CONVENIENCE. ITEMS ARE NOT SHOWN TO SCALE.
M5x40MM
M3.5x35MM
Wall Anchor
Screw Cap
Allen Wrench
Extra Hardware Pack
(1-4)
5

4 of 6
ASSEMBLY INSTRUCTION (50-SH01DW)
STEP 2
Using fourteen Screws (1), continue attaching the other four Shelves (C) and three Middle Boards (B) until all
are attached. With the remaining two Screws (1) attach the other End Board (A) to the last Shelf (C).
STEP 3
Push the twenty Screw Caps (4) securely onto the screw heads.
STEP 1
side facing you and place it to the right of the End Board as shown. Using two Screws (1) screw the boards
together with the Allen wrench (5). Then, attach one Middle Board (B) to the Shelf (C) using two Screws (1).
#1 x 4 Pcs
B
C
A
A
C
C
B
#1 x 16 Pcs
#4 x 20 Pcs
#5
#5

5 of 6
ASSEMBLY INSTRUCTION (50-SH01DW)
STEP 4
End Boards (A) and mark the wall behind. Using a drill or a hammer and a nail, make holes in the wall
where you have marked. Make sure the drill bit or nail that you use is smaller in diameter than the
Wall Anchors (3). Insert the Wall Anchors, using a rubber hammer if needed.
Align the shelf with the Anchors. Insert two Screws (2) through the holes of the End Boards and screw them
into the Anchors.
#2 x 2 Pcs
#3 x 2 Pcs
#3
#2
A

•
•
•
6 OF 6
Every 6 months, check all screws to ensure they are tight.
This product is California 93120 Compliant for Formaldehyde.
Comfort Products, Inc.
P.O. Box 999
Memphis, TN 38101
Comfort Products warrants this product to be free from defects in material and workmanship for one (1) year. This warranty is made by
Comfort Products only to the original end-user customer acquiring the product directly from Comfort Products’ authorized dealers
as shown by the original sales receipt. The end-user customer remedy pursuant to this warranty is limited to repair or replacement of
parts at Comfort Products’ option within a reasonable amount of time. Comfort Products reserves the right to require damaged parts
to be returned to Comfort Products upon request. Consent from Comfort Products must be obtained before any warranty work is
performed. This warranty applies under conditions of normal use and is not subject to defects caused by improper assembly or
disassembly; defects occurring after purchase due to product mo sure
to the elements; labor or assembly cost. This warranty does not cover the cost of transportation or labor. In no event shall Comfort
Products be liable in either tort or contract for any loss or direct, special, incidental, consequential or exemplary damages. This Limited
Warranty is NOT applicable to end-user customers who use Comfort Products for rental purposes. This warranty applies only to end-user
customers in the United States. All warranties are limited to the original purchaser for normal use. The weight capacity of the shelves is
10 pounds. For claims or questions concerning this warranty, please visit: www.comfortproducts.net or email us at:
[email protected]
PLEASE VISIT WWW.COMFORTPRODUCTS.NET FOR WARRANTY INFORMATION
www.comfortproducts.net
[email protected]
MODEL: 50-SH01DW
OneSpace is a Trademark of Comfort Products, Inc.
™