Onespace 50-JN173SHLFWN User manual

Wood and Steel 3-Shelf Display, Walnut
ASSEMBLY INSTRUCTIONS
MODEL 50-JN173SHLFWN
SUPPLIER CODE: JNFF
For fastest service on claims, requests for replacement parts,
www.comfortproducts.net/support
e-mail: [e-mail]
Keep your sales receipt as documentation of your ownership.
CUSTOMER SERVICE
or questions, please visit our website at:
OneSpace is a Trademark of Comfort Products, Inc.
™

ASSEMBLY OVERVIEW
Shelf
weight capacity
= 110 lbs.
2

PARTSLIST
#
DESCRIPTION
STOCK #
QTY.
1 3
2 3
52
6 2
3
THE PART NUMBER CAN BE FOUND ON THE SIDE OF THE PART, EITHER STAMPED OR ON A STICKER.
ITEMS ARE NOT SHOWN TO SCALE. NOTE THAT THE BOARDS BELOW ARE SHOWN UPSIDE DOWN.
Back Board 51-JN173WNBB
Shelf
Left Side Board
Back Frame
51-JN173WNSH
51-JN173WNSBL
51-JN173BF
Front Frame 51-JN173FF
33
Right Side Board 51-JN173WNSBR 34

4
EXTRA HARDWARE INCLUDED FOR YOUR CONVENIENCE. ITEMS ARE NOT SHOWN TO SCALE.
HARDWARE KIT
PART DESCRIPTION QT Y.
A
M6 X 30MM
Bolt
Cam
24
C
D
E
24
24
- READ THE INSTRUCTION MANUAL BEFORE ASSEMBLING.
- REMOVE ALL PIECES BEFORE BEGINNING INSTALLATION.
- OPEN THE HARDWARE AS NEEDED .
- ASSEMBLE IN AN AREA WITH PLENTY OF SPACE.
- READ EACH STEP BEFORE BEGINNING CONSTRUCTION.
- HAVE A SCREWDRIVER BEFORE YOU BEGIN ASSEMBLING
(NOT INCLUDED).
- NEVER FORCE THE SCREWS OR FITTINGS.
- KEEP THIS MANUAL FOR FUTURE REFERENCE.
- TIGHTEN ALL THE SCREWS EVERY 6 MONTHS.
CLEANING AND CARE
- CLEAN SURFACES WITH A DRY OR DAMP CLOTH.
- DO NOT USE ABRASIVE CLEANERS.
- DO NOT USE A POWER DRILL.
Allen Wrench
B
1
IF YOU ARE MISSING ANY OF THESE PARTS, OR IF YOU HAVE A DAMAGED PART, PLEASE VISIT WWW.COMFORTPRODUCTS.NET/SUPPORT
REFERENCE THE MODEL # ON THE FRONT OF THIS MANUAL. SIMPLY COMPLETE THE INFORMATION, INCLUDING THE PART YOU NEED. THE
PART WILL NORMALLY BE SHIPPED WITHIN 48 HOURS.
M6 X 35MM 6
STOCK # 51-JN173HA

ASSEMBLY INSTRUCTIONS
5
STEP 1
STEP 2
C x 6
2
D x 6
D x 18
C x 18
Attach the Back Board (1) to the Shelf (2) using two Bolts (C) and two Cams (D). Make sure the arrow on the cam is facing the
bolt. Using a screwdriver, turn the cam clockwise 180 degrees to lock the bolt into place. Repeat for the other two shelves.
The drawing below shows the bottom of the shelf.
Attach the Left and Right Side Boards (3 & 4) to the Shelf (2) and Back Board (1) using six Bolts (C) and six Cams (D). Repeat for
the other two shelves.
2
1
3
4
1
C
D