Opitec Hobbyfix Cube User manual

1
D108465#2
Please Note
The OPITEC range of projects is not intended as play toys
for young children.They are teaching aids for young people
learning the skills of Craft, Design and Technolo- gy.These
projects should only be undertaken and tested with the
guidance of a fully qualified adult. The finished projects are
not suitable to give to children under 3 years old. Some
parts can be swallowed. Dan- ger of suffocation!
108.465
„Cube“
Labyrinth in 3 layers
(acrylic )
Parts list
Quantity Size(mm) Description Part No
Acrylglasstreifen 2 2x90x190 layers 1
Pine strip 6 10x20x250 frame , labyrinth 2
Steel ball 1 ø10 3
Necessary tools
Pencil, ruler
Wood glue
Fine saw, mitre block
Pillar drill 15mm diameter.
Sand paper / wet dry paper
Warning!
This product con-
tains small parts that
can be swallowed
There is a danger of
choking

2D108465#1
Instructions
1. General: Using the materials given the cube can be made to the instructions or your own design ( The full size
patterns are on page 5 )
Note:
The holes are 10mm diameter. The pine strips for the labyrinth must have a gap of 11mm.
2. Check the design for your labyrinth carefully before starting to cut any wood.
Make up a cutting list for the pine strips.
3. Mark out and saw four squares 90 x 90 mm from the acrylic ( See diagram 3 )
4. Mark out the position of the hole on the acrylic sheet. 1
5. Drill the 15mm hole with a pillar drill ( Drill in two steps rst use a smaller drill )
(Please take care to adhere to the safety rules when drilling and use a scrap piece of wood as an underlay)
Note!
You can drill both top and bottom holes at once. The position of the second hole is marked on the plan with a bro-
ken line.
6. Cut the pine strip according to your list ( Take care with the quantity of material supplied )
7. Sand the pine strips
8. Glue the strips on the acrylic ( See diagram 3+4 ) Use UHU all purpose
or a similar glue
Note!
Take care with the position of the holes
9. Once dry you can assemble and glue the layers together. The best way is layer 2 with layer 3 & then layer 1 with the
lid. Leave to dry and then glue layer 1 to layer 2
Hinweis: Position der einzelnen Ebenen beachte, dass nicht 2 Bohrungen übereinander liegen!
10. Den Cube außen versäubern und evtl. die Holzäche mit Lack, Wachs usw. behandeln.
Viel Spaß mit dem Labyrinth-Cube!
Layer 1
Lid Layer 2
Layer 3

3
D108465#2
18,5
18,5
18,5
18,5
90
90
Ø 15
Ø 15
80
50
17
17
16
Lid and bottom for all the layers
Layer 1

4D108465#1
80
20
20 50
17
17
17
50
20
20
17
17
17
80
Layer 2
Layer 3

5
D108465#2
Anlage 1
Note:The patterns have 10x 10mm squares! Make sure that the labyrinth strips have a space of 11mm and that the holes in the
layers are not larger than 10mm diameter.
Stückliste: