Opitec 112.994 User manual

1
D112994#1
112.994
PARTS LIST
Description
PLywood 1 120x100x8 Body,goal,legs 1
Plywood 1 100x30x4 Body ,base 2
Wooden ball 1 ø 20 Head 3
Wooden ball 1 ø 15 Press button 4
Dowel 1 100x4 Axle 5
Screw 1 2,9x16 Leg xing 6
Brass tube 1 8x4 Guide 7
Tipp-Kick Ball white/black 1 Football 8
Necessary tools
Fretsaw
Wood glue
Ruler and pencil
Sandpaper
Drill ø3/4/5 mm
Crosshead screwdriver
Paints and brush
Pocket "Finger-Kick"
Please Note
The OPITEC range of projects is not intended as play toys for
young children.They are teaching aids for young people
learning the skills of Craft, Design and Technology.These
projects should only be undertaken and tested with the
guidance of a fully qualified adult.
The finished projects are not suitable to give to children
under 3 years old. Some parts can be swallowed. Danger of
suffocation!

2D112994#1
Ø 4
Ø 3
Ø 4
100
120
100
30
Ø 4
Ø 3
Ø 4
100
120
100
30
INSTRUCTIONS
1. Trace the patterns (Page 3) on the plywood sheets (see
diagram)
Before cutting out the parts drill the hole in the leg
4mm dia (b) Use a bradawl to mark the middle point in
the body.
Saw out all the parts with a Fretsaw and clean up the
edges.
Note:
Saw out part f from the plywood sheet (2) at the end
, otherwise it will be more dicult to cut out the small
parts (g,h,i)!
a
b
c
de
f
g
h
2. Making the body take part (a) Parts (g, h)
and (i) are glued on part (a) as shown.
Sand the edges!
a
g
i
h
3. The wooden ball (3) is glued on the
body. take care that the wooden ball
sits properly on the gap in the body! Use
a dowel .Once dry drill a 4-4.5mm
in the body.
4. Insert the brass tube (7)as shown
(4mm) in the leg (b)
5. Insert the screw (6) throught the brass
tube bearing and x it in to the body.
Note the leg must move freely.
6. Shorten the dowel (5) to 60mm, insert
it in the wooden dowel (4) drill the ball
out to ø 4mm if necessary!
7. Insert the dowel in the wooden ball
head. The weight of the leg (b) ensures
that the footballers leg (b) is always
ready to kick!
7
2
i
Leave gap of 4mm ,use do-
wel as spacer!
b
3
4
5

3
D112994#1
Ø 4
Ø 3
Ø 4
100
120
100
30
Ø 4
Ø 3
Ø 4
100
120
100
30
i
INSTRUCTIONS
8. Mount the gure on the base (f) as
shown!
9.Glue the supports (d und e) for
the goal posts(c) and leave to dry
10. Finished!
You can now decorate your model with
acrylic paint as you wish
Note:
Do not get paint in the holes or on the do-
wels as the function will be impaired
Pattern
8mm + 4mm plywood
Scale 1:1
a
b
c
e
d
f
ih
g
8 mm
4 mm
f
c
d
e